Tondiamo Rubber Stamp Sheet for Laser Engraving Machine, A4 Rubber Stamp Sheet for Laser Cutter Soft Rubber Sheet to Make Rubber Stamps, 2.3 Mm/ 0.09 Inch (Light Gray) (Light Gray)

Decent quality, worked for my needs

Worked great on a 40W Epilog Fusion Edge laser engraver. Smell was minimal. Not sticky & very crisp design. Perfect thickness.

The rubber engraved really well for what I needed it for. Made a stamp for my son’s wedding invitations.

My first time making a rubber stamp with the Glowforge Aura. This rubber cuts smooth & delicate details are not lost. These stamps I made was only 1" in diameter. There is a lot of dust that need to be cleaned up & mini vac is highly suggested. Amazon says the material is .09, but my caliper says .08. So you may need to test yours. The settings I used were: Unknown Material: .08 Engrave: 100 / 10 / x4 Cut: 100 /10 / x10 Twice The cutting is where it got tricky. 10 passes, the limit on the Aura, is not enough to get through the rubber all the way. What I did was do a first Cut & Engrave session, then I changed the engrave layer to ignore so that the only thing left was the cut layer & hit “Print” again. Even this was not enough to go thru the rubber completely. However, It was so close that I was able to “pop” out the stamps. You could probably do a third round if you want.

Worked great with my diode laser.