AC Flush Kit, Car Air Conditioner System Lines Flush Gun Kit, AC Flushing Canister Bottle Cleaning Tool Set for Auto Car with 3.5 ft Hose Interface (Updated Version)

Simple to use, assembles well, no leaks. The i received has a well finished interior, no tailings from milling etc. Cleaned it anyway before first use.If you pill the trigger hard the contents will spray out very fast, you will go through a lot of solvent that way. But i have found that if you use the trigger gently you can control the flow rate and reduce the solvent wastage. Hook it up to a compressor and away you go.Excellent product, regardless of where it was made.

Awesome must have item to flush Evap I used denatured alcohl with it and made sure it was "dry" then did vacuum AC works just fine now after Compressor failure

This is a pretty nice solvent pressure bottle, with an accurate pressure gauge, and hose/nozzle. It has served it’s purpose well, while flushing my A/C system. Please be aware, YOU MUST wash out the bottle well, before you use it. I found a lot of metal dust inside, which can possibly mess up your project. Also, dry out the inside of the bottle soon after use.; shoot some dry air inside the bottle with a heat gun, or hair dryer. Folks, this is low quality stainless, and it will corrode on the inside (MADE IN CHINA). The exterior of the bottle is nice, but the inside is crap. I would have gladly given 5-stars, if not for that.

This thing is great for cleaning out a/c lines. The compressed air is the way to go with a good cleaner. A must have if all components of the system isn’t replaced.

Great tool for anyone flushing their AC system when doing a repair

Tried this out on a ac overhaul I did on my wife’s car. Worked excellent

Works great for what I need it for

This is my first time doing my own car A/C service. I bought a 2005 Ford Escape that had the compressor or ??? give out and crap the system up badly. So with new parts, compressor and condenser I set about to do it right.First step was to clean the evaporator with his tool and 2 quarts of Supercool cleaner. Out of the box the installed air line fitting is too fat. OK, I happened to have an old one & it went on with some Teflon tape no problem.Next, upon pressurizing the can the fittings and on-off valve leaked all over. OK, tighten everything up. All is good now.Then I discovered this tool squirts a quart of cleaner out in a few seconds. I don't know about other brands, but it goes quick. No way to reduce the fluid quantity in the spray, so you get what you get. It took almost two quarts to get all the old grunge & PAG oil out and clean.It may be against the rules, but on my next use I will fill the can with some de-greaser/ soap & water first. Then as the final wash run the expensive cleaner through as a final wash and dry.