kemimoto utv harness pass-through bezel, Seat Belt Pass Through Bezel Insert for Polaris RZR XP1000 900 S XC General

The directions were good. There are a few you tube videos that also helped with the install. Definitely use a Dremel to cut the back of the seat. Using a sharp knife will not work. They said not to trim any foam on my model, however I found it necessary to do so for getting the bezels to marry.

Fit nicely, once you figure out what you’re doing. Installed (4) in about an hour.

A little hard to install the first one but after that, they were easy. Watch some on line videos before you start, there’s plenty of them online. I used a Dremel with a small cutoff wheel, a box cutter with some fresh blades, a long “click” knife, and a 1” hole saw. The trick with the hole saw was to shorten the pilot drill bit and drill easy.Fist one took 2 hours, second one 45 min and the last two took 15 min.

With a little bit of Noel little patience this product is pretty awesome. I did it one evening 2four seats on my 18 Rzr. 3 inch belt was very easy to put through them now or you can ride and comfort

These aren’t expensive but not the cheapest. I tried the cheapest…they sucked. Bought these and had NO ISSUES.SOLID PLASTICRETAINS SHAPE