Rosewill ATX Mid Tower Gaming PC Computer Case with Red LED Fans, 360mm AIO Water Cooling Radiator Support, 3 Sided Tempered Glass, Great Cable Management/Airflow - CULLINAN MX-Red

This was an absolutey phenomenal product. I was iffy on getting it, but after a quick skim of all the positive reviews with high ratings, I grabbed it. Now for the rundown, as well as a detailed look at what it features and tips on building in it.Update 2023-04-26Guess what? I'm STILL using this case. It has gone through four builds and EVERYTHING is still running with no issue. If that doesn't tell you to buy this case, I don't know what will.There is plenty of room to work where you need to.Both right and left temepered glass panels come off, and utilize large, thick screws with grips on them making it a cakewalk to do.The entire front plastic cover pops off, exposing the air filter.The air filters are 1. Metal-like material, 2. Magnetic. This means that removing them to clean them is amazingly easy.The four fans you see featured are preinstalled, and large in size (120mm). This means you don't have to buy any fans to go with it (I made that mistake, but at least I have extras now)The right side of the tower is designed incredibly well - here you will find the slot for your power supply, the 3 thin slots for your solid state drives, and the 2 pullout trays for your hard disc drives.On the bottom of the unit, there is a fan cutout for your power supply, and a rubber guard separating the PSU housing from where the motherboard will be, making wire management easy as any excess wires can simply be stored underneath in the PSU cubby.Speaking of fans, they are so silent you can't hear them. No I'm serious, the fans make zero noise. The only noise you hear is air moving, but the fans themselves just seem like they aren't there at all. It also helps that the tempered glass covers have rubber seals where you screw them in, meaning it also blocks out a lot of the internal noise.The three fans in front pull air in from the sides, and the rear fan at the top of the back blows it out - it's a very well designed air flow system. The air flows in and is guided up and to the top allowing the cooler air to remain in the tower longer to soak up the heat before being funneled to the back top, meaning the air flows where it needs to and stays long enough to actually collect heat in the first place.The top filter area of the tower is nice and long, 360mm to be exact - with the various mounting locations you can put screws in (it also comes with screws for every hole you see) it's easy to mount a water cooling loop, or more fans. The top also has premade holes, so mounting fans or a radiator + fans for your water cooling loop is incredibly easy.The kit comes with spare screws, for us less agile folk - losing a scew or two isn't nearly as bad.In the back, there's a little slide you can lift up - unscrew the screens and put in your graphics card. Then, you can slide it back down - it covers the bright metal piece that you screw in and makes it look much nicer and cleaner.That's all I can think of to cover the great functionality of the product, let's move on to notes of interest.Make sure your power supply has SATA connectors for future projects.The power, reset, and button lights respectfully are already Velcro'd and nicely together so you don't have to fool with organizing them.I don't know if you'll have this issue, but if you build everything and power the PC but your fans aren't working - don't fret! There is a switch on top with the letters L S H or something similar (can't remember ATM) , I had to switch it to the right to get the fans + their lights to work. If you switch all the way to the left the fans will run but won't be lit up.The 4 pre-installed fans aren't connected to anything - what you actually want to do is connect them to a little black board on the right side of the tower, these have 3 prongs in them to fit the fans on to, and the black board is what will connect to your motherboard - so the only motherboard fan slot you use is the CPU one, the others aren't needed - if you have a three pin connector. This is actually what makes the fans run so keep in mind the motherboard won't recognize them (with the exception of the CPU fan, if you are not water cooling.)Well, that's all I can think of to mention. Overall this is a fantastic product, and with its fantastic price tag (I got mine for just 70 - 80 USD) it really can't be bested. This case I'd absolutely recommend to anyone, and will be using it in all future builds.

I bought this case for a new rig from scratch. So far I have put this stuff in it.-Ryzen 5-GTX 1080-ATX mobo-1 SSD- PCI Network Card- 750 EVGA PSUIn general this is a great case with excellent optimization for pretty much any utility needs of a computer. And it is beautiful.Pros:-It is pretty. The glass looks great, no bubbles or anything, it is tinted which is good or bad based on preference.-The airflow is immense. For both CPU and graphics cards. I have yet to get above 72 degrees C for both cpu and gpu under full load with stock coolers while OVERCLOCKED, with fans running at 8 volts, awesome. The fan on the bottom pushes air through the empty PCI areas well if it isn't full of stuff. Even with the PCI Network card it is great.- Fans, It comes with 4 stock. I haven't switched them out, they are quiet and have a pretty blue color. It comes with a fan controller (I think can run 6 fans) for the front three fans with a switch on the top of the case to adjust for low speed no LED, and high speed with LED, and off. The rear fan LED's run off of how much voltage gets put through it, since I haven't hit 80 degrees with my CPU yet, I haven't seen it full brightness, but that is changeable in the MOBO settings, so it's no problem.-The Cable management is great. It is all hidden behind in the back pane area, there is efficient clearance to run flat cables anywhere you want, and enough ways to run cable anywhere you need for any MOBO.-You can put 6 2.5 inch SSD's along with 4-5 3.5 inch HDD's, keeping all hidden. so you can even put some more in PCI slots. At this point you are limited by your MOBO and PSU. I highly doubt you will run into a storage problem.-The magnetic air screen filter out any major dust or pet hair etc. effectively and without reducing airflow noticeably so this is good.-It run's pretty quiet, The nosiest thing I can hear is the stock cooler running at 1900 RPMs. Even so I can't hear a thing with headphones, and can still hear the tv out in the living room with my door shut. It is sufficiently quiet. My last decibel test read 26 decibels at like 10 inches from front.-If you want to put LED strips to light stuff up, there is plenty of spot to do so, as well as clean cable management (actually, you only really see the gpu power and 24 pin cables). You can show your rig off in style.-If you were to put a water cooler in, it can fit any radiator up to 360mm on the top, as well as a 280 if you want. The only problem would be with your MOBO set up.- There are many many mounting options for MOBO's you shouldn't have any trouble.- Comes with a lot of utility stuff like mounting screws and etc.Cons: Only individual preference things really, or things to be expected with this type of case. Really not much of a problem.- No SD slot if you want one.-The power button is easily pushable on accident if you are messing with the headphone jacks, fan controller, or usbs on the front panel.- The shroud for the psu eliminates the possibility of putting PSU upside down with the fan up if you want to.- If you like to put stickers on your case bigger than 1" inch square, unless you put it on the glass there isn't much space to put them.- It is heavy, but that is to be expected with a bunch of glass that is a 1/4 inch thick. Smudges are expected to happen with glass as well.

Me encanto, un excelente gabinete y muy muy economico, los materiales se sienten muy bien.

There's nothing I dislike about this case. It was at a decent price when I bought it, it dissipates heat very well with its 3 front fans and the single back one. The top being open (it has some dust protection) also helps a lot with keeping the whole PC cool. Wires are hidden, thus we only see the hardware through the glass. Its well compartmented too.The fans make no noise. There're plenty of USB-3.0 connectors on the front pannel. It's easy to clean (takes 30 seconds to open the front panel to clean the dust filter). It takes about 30 seconds to remove the side pannels and reorganize the hardware.I highly recommend it.

Este gabinete simplemente es fantástico. Estuve buscando durante unos 15 días un gabinete que satisficiera mis necesidades, las cuales eran:1. Cristal Templado (no obligatorio, pero si un punto fuerte a favor)2. Espacio para mínimo 5 HDD (2 de 3.5 y los demás de 2.5)3. Espacio para ventilador trasero de 140mm.4. Fontal visible (tengo unos AER RGB de 140mm y quería que lucieran)5. Que no pasara de $160 dólares (aprox, $3,000 mexicanos)Anteriormente tenía un Phanteks Entho Evolv Atx, que, aunque cumple con los puntos 2 y 4, simplemente no podía lucir el case como era debido. Además, sus rendijas de ventilación eran muy pequeñas, por lo que tenía que estar constantemente subiendo la velocidad de los ventiladores para poder ajustarlos a unos valores óptimos, por lo que decidí cambiarlo. Puse sobre la mesa el MasterCase Pro 5, el Masterbox 5, el Nzxt H440, el Phanteks Entho Pro M y P400, el Corsair Carbide Air 540 y 740.... en fin, muchos cases, pero ninguno cubría al 100 mis expectativas. El case es lo que entra por los ojos, lo que enamora de una PC y no podía comprar un gabinete del que tiempo después me arrepintiera. Estaba a punto de comprar el Carbide 740 (de hecho, lo agregué al carro, pero cuando le di a pagar la tarjeta no paso) cuando decidí hacer una última búsqueda simplemente con Tempered Glass y filtrarlo por Computación. Fue en ese momento que buscando en los resultados apareció este gabinete, del cual simplemente me enamore. Tiene todo lo que necesito y quiero, excelente acabado, diseño, elegante, materiales de construcción, etc. No pude encontrar un mejor gabinete. Los paneles de cristal le dan un toque sofisticado y bello y si le añades una tira de led RGB, el resultado es mucho más vistoso y atractivo. No puedo estar más contento.Si deciden comprarlo, se los aseguro, no se van a arrepentir.

Wie gesagt ist der Hammer sieht geil aus und ds einzige was fehlt sind die schächte für die Festplatten leider nur für drei platten erlaubt

I can definitely recommend this case for the sale price I got it at (about $110 CDN) but if you don't like tempered glass than you'll want to look elsewhere. If there is one thing to be aware of is if you have an older mobo is you will need a tool to move of Standoff for it to fit securely so make sure you have a socket tool to deal with that. Super sleek and looks great in low light. Love it