BilgePump Plumbing

Does the job thank you!!

Nice Kit. I installed the thru hull in under a minute and my Bilge System was draining water soon after!The hose may have to be longer.Key Point: The larger the Pump output in Gallons per hour , the larger the output on the pump. This fits the 500 and 900 gph.* Check the size of your pump before you buy this kit. This Kit is great quality and stainless steal clamps, just don't do what I did.I bought a 3500 gph pump, but the hose was to small. I finally found a 900gph pump that worked.* You can use Duct Tape around the hose to make it bigger. Not perfect but a tip.

My bilge always got some water and found it was coming from the in-hull drain that sits close to the water line. Extended the hose higher(closer to where the rub rails would sit on the other side of the hull). Coiled it at the drain to create a trap. Tested the bilge pump to see if water can be pumped out traveling up the hose and pass the trap. Works great!

It felt cheap to be quite honest. Thin material makes me wonder how it will hold up in the weather. We’ll find out.

this is a good kit and an exceptional value during the off season but the price almost doubles when the season starts. This kit contains 6 feet of plastic hose, a stainless steel clamp and a through-hull fitting. I paid more for three feet of the same kind of hose at a marine supply store than I paid for this entire kit in the off season. It's decent quality and works well with my Sea Sense bilge pump to keep my 12-foot boat clear of rain water during the winter when I'm not using it.

Perfect fit for the SeaSense bilge; pump, and has non-corrugated sections every so often to cut and install. For stuff like this, better to just buy what's made special for it vs. trying to rig something like I previously had.

This hose is corrugated both outside and inside.Unfortunately hose that corrugated inside reduce water flow by 25-30%. Not something you want for your bulge pump...I’ll be returning this.

WORKED VERY WELL