🔥 Heat Up Your 3D Printing Game! 🔥
The Silicone Heater 310x310mm for Creality CR-10 is a high-performance heating solution designed to enhance your 3D printing projects. With a powerful 750W output and a precise size of 310mm x 310mm, this heater ensures optimal temperature control and quick heating. It features four pre-made screw holes for easy installation and is perfect for both hobbyists and professionals looking to elevate their printing capabilities.
| Manufacturer | Keenovo International Group Limited |
| Part Number | K31003100750120NPH |
| Item Weight | 2.2 pounds |
| Product Dimensions | 12.2 x 12.2 x 0.06 inches |
| Is Discontinued By Manufacturer | No |
| Size | full size |
| Pattern | 120V |
| Wattage | 750 watts |
| Item Package Quantity | 1 |
| Batteries Included? | No |
| Batteries Required? | No |
S**A
Very fast heating. Quite uniform heat distribution
I bought this for upgrading my CR-10 heated bed which is very bad for materials like ABS or Polycarbonate. Installing this was a few hours DIY project. I set it up with a 40DA SSR (kept the extra amp so there is less chance of SSR failures) and difference is very satisfying. It heats up so fast that even for ABS temperature of 110C it takes less than 2 mins. This one takes around 6A while running which found from a Kill-A-Watt watt meter.I did make sure to ground the aluminum bed and the SSR also along with a 10A inline fuse since it is direct 120V AC.
R**2
Customer Service Offered Poor Solution/Compensation
This is a great product, however, after about 6 months, my thermistor failed in the middle of a print. Keenovo only offered a $2 refund after I purchased this for $75, and then they told me to install a thermistor on the outside, which I'm sure will degrade the performance. I'm not accepting that offer, and requesting a full refund or replacement.
K**N
Heats up to 60c in about 30 seconds, can print ABS on CR-10 without enclosure
Used on CR-10S, heats up much MUCH faster. 60c in about 30 seconds and I am able to get up to 135c (limit of printer firmware) so it enables me to print ABS without an enclosure. You do have to use a relay and rewire your control box to use this, I used a "SSR-25 DA 25A 3.2-32V DC/24-380V AC" available on Amazon as well for around $10.00There are several how-to videos on YouTube for instructions on wiring
W**H
Great heating pad it is 120volt so you do have ...
Great heating pad it is 120volt so you do have to wire through a relay or external thermostat. Heats up fast.
A**A
Five Stars
Works great heats up fast and works great with the SSR
R**Y
Five Stars
Excellent Purchase! even arrived almost a week earlier than predicted! Highly recommend!
D**N
Clean to install, heats fast.
Clean to install, heats fast.
R**B
Five Stars
It gets hot quick
Trustpilot
1 day ago
4 days ago