NI -WA 06 LED Light Bar Wiring Harness Kit - 2 Leads 12V On Off Switch Power Relay Blade Fuse for Off Road Lights LED Work Light, 2 Years Warranty

I don’t normally write reviews, but I had to on this one. I use this kit to wire up LED lights that are built into my aftermarketfront bumper on my 1985 CJ 7. This kit not only did the job, but it’s very well-made and easy to hook up. I’ve never hooked up a set of driving lights or fog lights that were this easy highly recommended especially at this price!

Gets the job done - These are excellent kits for adding additional lights or accessories to your rig, It includes everything you need except the lights. Very easy to install.

I installed about three months ago never had an issue no flickering water resistant switch works very well. Everything is including especially connector buds and I am very happy with it. Highly recommend.

Great quality

This made it easier to install fog lights on my 66 mustang no need to make your own wiring harness comes with everything you need. I did had to add more wire to the button thats it

I actually used this for a manual fan switch on my atv, works perfectly, very high quality

2024-08-28 ========= It's been under ten bucks lately, so for that price - it's pretty good. I can't speak to the quality of the relay (the main wear item) as I just installed it (and I ordered a second one), but other than that it seems pretty solid. The wires from the relay to the lights are too long, and the ones to the switch are too short, so even on a compact car, I had to extend them (16 ga). The connectors to the lights are just wire spade crimp connectors with small plastic shrouds (provided), which isn't so great for something that will be enduring the worst environmental conditions, so I had to protect them with electrical tape (shrink tubing would have been better, but I didn't bother). I needed to add two sets of auxiliary lights on my Impreza (wide and spot), and I wasn't about to run two sets of wires around the engine (the firewall's entry point in on the opposite side from the battery and the driver position), and given that there is no necessity for running six wires for two switches, I decide to make some changes to the wiring. You only need the white one, the others are just ground and, it should be, switchable +12V (not always-hot); you can get those from the inside fuse panel. For that purpose, I needed to come up with a schematic of the harness, so I'm attaching what I believe is accurate. Generally, there are better ones, but this one should be good enough, if you know your way around electrical connections.

Discovered the passenger headlight was not functioning properly even with a new bulb. Found a butchered wiring harness so I decided to replace it with this. Works beautifully. Took me less than 30 minutes to install.

my 2nd set and loving them so far..

Excelente producto. Lo monté en un jeep tj 03. El cableado queda perfecto. La localización de relevador algo justa, sería bueno que viniera un par de cm más largas las puntas de las terminales. Hice el cableado por la salpicadera derecha, cruce por el tubo del chasis detrás de la defensa y el botón lo metí por la pared pared fuego y elimine una toma de 12v para poner ahí el botón.

Great product and good quality 😊🙌

Very good quality product. Totally satisfied with the purchase. The rocker switch provided by the company is suitable for car dashboard, not suitable for bike handlebar mounting. As I'm going to install it on my bike I have to make some minor modifications with the switch. So deducting 1 star.. Otherwise very good product. 100% recommended..

無事接続完了です！