42137 Aqua Magic II Base-White

Hi everyone! So my old RV Toilet's flush handle came off and this product seemed to be the answer and it was! Everything went as expected except for attaching the bowl to the base. First of all, in order to get the leverage, I had to install the base over the bolts so I could twist it hard. However, it would not fully engage the tabs and thus not align with the bolt holes in the base. I found that the tabs were pretty flexible and found that a minor bend to each allowed the bowl to engage all four tabs. But for some reason, the hole in the base did NOT align perfectly with the bowl. But was able to get the bolts in and that is all the mattered. So all is good! :-) Good luck!

This is the exact replacement for my Thetford RV toilet base. It is fairly easily installed, although the instructions are sort of cryptic - they are trying to do too much on a small document. I had to remove and replace mine a 2nd time because I installed a gasket upside down! The quality of the hardware included was good, again identical to the original.

Im so happy that my toilet finally holds water! Its one of those things that you should've done a long time ago. Im happy with the shipping and thankful it came with all the accessories needed.

I simply can't comprehend how a defect like this couldn't have been caught at quality inspection! It is so obvious and has wasted my time and effort. Thetford ... not a good effort on their part. Ok returned this one and ordered another ... the new one was packaged well and did not show any damage. Installation however, was another issue. For some reason the place where the top seal is placed in the old base was formed into the plastic of the base. The new version has a small circular piece that gets inserted into the throat of the base ... but it will not stay put ... keeps creeping out making it impossible to attach the bowl to the base because one cannot compress the bowl onto the base with enough force to both seat the insert and twist the bowl into the 4 little "fingers?" that hold the bowl to the base. Two little screws were need to hold the piece into the base so it would stay put. Next issue is the little fingers that hold the bowl to the base. These did not stand high enough to allow them to slide properly to connect to the bowl to the base when attempting to twist onto the base. A pair of channel locks were used to bend the little fingers upward so that eventually they would clear the bottom of the bowl allowing the twisting of the two pieces together to actually happen. So a 30 minute job turned into a couple of hours and wasted colorful language phrases that could have been put to better use.

Worked perfect, no problem, easy to install and a great price. Highly recommended it and the company

Perfect fit good value

Yeah! This is the best way to fix the RV toilet. No small parts to piece together in gross areas, just buy this brand new unit and put the bowl on. Make sure to re -tighten the mounting bolts at the floor after sitting on it.

Good product, packaged nicely . Works great