Practical Comfort Aluminum Kitchen Drawer Organizer for Silverware Utensils Flatware 18 Dividers Set | MEDIUM

Just finished installing these dividers on four drawers. The concept of these dividers is fairly solid, a take-off from Blum or Rev-a-Shelf perhaps. The design difficulty is making the compartments adjustable while still fitting solidly in the drawer. This kit consists of two long rails which extend from front to rear of drawer, and several short dividers which determine the width of the compartments. The long rails attach to the front and rear drawer sides using two adhesive pads. Cabinet drawers come in standard front-to-back dimensions and the adhesive pads are designed to accomodate standard drawer lengths. In other words, the front-back dividers cannot be adjusted so make sure you measure that distance accurately when ordering. Since there are only two long rails, your drawer cannot have more than 3 long divisions of the drawers - left, center, right. What you can adjust are the cross dividers which (mount) clip onto the long rails. They are designed to clip on anywhere so you can have several within each long opening. To accomodate your choice of width, the dividers come with "fillers" (that is pieces of plastic approx 1/4"" ) which you stack together to get the width you want. You can then acheive a width of about 2 inches (using no fillers) to about 4 inches by stacking them together. Anything made to be so adjustable has to give up some rigidity. In this case it is the long rails which are held in by flexible adhesive pads. If you are sure of rail placement, it would be easy enough to drill a hole in the adhesive end cap and insert a small screw into the front and rear of the drawer. Here's a trick to assist in installing the rails correctly. Onto the two rails, assemble two temporary cross dividers, front and rear, with enough spacers such that the rails are in approximately the desired position. This will result in a tic-tac-toe configuration and allow force to be applied in a diagonal direction to hold the frame in a square position while the adhesive pads are installed and uncovered.You will feel confident in assempling these dividers just as you finish the job! It is easy to drop, dirty or install the adhesive pads crooked. I hope the factory will send me a couple of extras.*** Added 01/2027. Had an occasion to look carefully at the previously mounted dividers. By now the adhesive pads have lost most of their adhesiveness allowing the entire divider assembly to move around. If I were to use these again (competing products almost impossible to find or afford...) I would drill a small hole in the sticky pad holders in which to place a wood screw. Not easy but quite necessary if you want a stable divider. Divider sets seem difficult to buy at a low price so I put up with these including the warts!

Love these dividers! They absolutely do the job! Ordered more sets

This system is exactly what I was searching for. First words of advice: Measure your drawers. Just do. I didn’t and I ordered large thinking to myself my drawer was large and it wasn’t. So if you’re thinking your drawer space is too large for this kit, it’s probably not! I had to return the kit for a medium, which was no problem. Quick and easy service and I received the new kit within two days. It’s easy to assemble but you must follow the instructions which are pretty detailed. I’m happy with this. The only problem is that I stuck some of the long dividers with the wrong side down so the separators don’t sit quite right as you can see. This is my fault and not the manufacturer’s so I don’t dock them any stars for that. Though I do wish the stickies on the ends were removable so that I could flip them over. But they’re not. Once you stick them, they’re stuck. So be sure you lay out your design before affixing to make sure everything is where you want it to be. My husband is happy with this too. This drawer was a thorn in our sides while cooking but now it’s so much better. You need this!

Once again, someone ALMOST made a good drawer divider, but the sticky gummies that are supposed to support it against the drawer sides don’t work after a week or so. I will have to drill some holes so I can attach it to the sides of the drawer with small screws.

These dividers did a great job to help organize my drawers. Modification was needed for some horizontal dividers (trimming them down with a saw was not ideal) so that they were the appropriate size. They are not adjustable like the vertical ones. It would have also been nice to have adhesive for the horizontal dividers so they don't wiggle (minor issue, though my OCD sets in when they aren't straight). Finally, it would have been nice to have some deep pocket end pieces because the ends where they meet the front where your handle hardware is are not ideal. Hopefully the small portion of the adhesive where it touches those screws does not come off. Otherwise, very happy with my purchase.

Lost my silverware drawer with the built in dividers when I installed a dishwasher. Needed to move silverware to a different drawer that is about 19" x 19". Looked at a lot of flatware trays, even some that expanded, but they all seemed to leave wasted space in the drawer. I ran across this system on Amazon and was initially reluctant because of the cost, but couldn't find a better option so I decided to give it a try. Glad I did. I bought the medium length set with 3 long and I think 6 short pieces. The kit also comes with extenders to make the short pieces longer. Pros: The pieces are sturdy. The adhesive pads that hold the ends are easy to work with, repositionable, and do a good job of keeping the rails from shifting. It looks great once installed I think. Because my drawer was so wide, I decided to install the rails sideways and it works well. All the silverware is easily reached without opening the drawer all the way and the whole back of the drawer is open for larger items. Cons: The long rails can be a little hard to extend. The short pieces are hard to impossible to slide or move once snapped on to the long rails., but I just pulled them off and snapped them back on in the new position. The short rails were longer than I needed. I didn't need that much width in each slot for forks. Wish there waa more flexibility on how many long and short rails you order. I only used 3 short ones and plan to order another kit for a different drawer which will also come with more short rails than I need. Overall I would recommend this for organizing a drawer without wasting a lot of space.

This made our large drawer so much more organised and easier to use. See picI bought two in order to get enough long pieces to make the compartments I need. However I thought because our drawer was so large I must need to buy the 'large' size, after reading the reviews I ensured I measured and I'm so glad I did! My drawer was 'small' and it fit perfectly - to do make sure you measure.Expensive but very versatile, happy with purchase and outcome

Nothing else worked with my drawers that have rounded sides. Regular solutions made me lose precious space. What I like about this one is that it's fully customizable. If you want bigger spaces, smaller spaces, wider, thinner, up to a point, it will work. They give plenty of pieces to do it. Once you install it, it looks like it will move, but no, it actually stays in place very well. I've had it for a year, and despite the expensive price, I recommend it to everyone who visits me. I wish they made smaller width pieces to make it work for my utensils drawer too.

Very basic and cheap product. It doesn't hold in place. It keep moving around in the drawer. Just taking and storing the utensils moves it. Also, but it's as the dimensions says, it doesn't cover much space. I would need 2 or 3 of those for 1 full drawer (30 inch).Worth at maximum 15-20$ and even there, I don't think I would buy it. Definetly not it's 83$ price tag...I'm returning it and buying a good old fashioned organizer.

commander le modèle 9 sections pour compléter mes autres tiroirs. bonne construction solide et ajustable. Je le recommande.

Too shallow, not sturdy and overall cheaply made.