Chrome Tilt Manual Style Manual 28'' Steering Column w/Wheel Adapter No Key Hot Rod GM

Very well made and looks great.

Arrived on it is what they what they said it was

Nice

I have a defective steering column but can’t return it because it’s been 4 1/2 months since I purchased it. I haven’t even driven my car yet.

Cheap column, cheap parts. Had to make a bracket to fit this 82 c10 however to put the column where I wanted it, I had to modify a bracket under the dash due to the fact that the keyed column ignition switch is mounted differently than an original gm column so it was in the way, if you don't know how to wire a gm column you'll Need instructions, we install dozens of these style columns so I don't need instructions but some people will. It will not come with connectors from my experience so you'll need to source them also. Especially if you purchase a Keyed unit. Got it wired up and the truck would turn over but wouldn't run. After inspection the ignition switch ( the part in the lower end if the column, not the lock cylinder) was not sending the coil wire power when it was supposed to. They're adjustable however that didn't help as then it would work a few times then not, so I just went and got a new replacement switch from oreillys (part #US95) and adjusted it where it worked. After that so far so good. We use a lot of these type of columns and usually the ones with the integrated key are the ones that cause issue. I've used $1000 columns and $200 columns. They all work fine if you know how to install them. The key ones are the only ones we've had issues with. Once you buy a quality ignition switch you're good to go. And this particular order the column arrived in a very distressed box that as way too big so check it good before installation. It's not a bad product but you get what you pay for 99% of the time.

This was a tilt 32-in and for the money you cannot beat it. I only recommend buying the wiring connector for it.

Poor quality you get what you pay for shifting pin will not stay in

Used it to replace 86 IROC column in my 1951 Int PU Nice