HOUHUI Motion Sensor Strip Lights,5M Dual Control Motion Activated Under Bed Light,Battery or USB Powered LED Under Cabinet Light with Auto Shut-Off Timer,Warm White Strip Light for Bedroom,Stairs

Bought two packs of these to put some lighting under my older parents bed, so they could see to get out and go to the toilet at night, and they are perfect for that. Never bothered with setting them up with the app, just set them up to a nice softish colour away from the blue spectrum to not disturb their sleep hygiene. Also put one under the bath as a soft glow for the bathroom for the same reason. As picture enclosed, Camera shows it a little whiter than it is, but more of a yellowish orange colour in real life. This is at about 50 % brightness and is plenty to light up the whole bathroom, and the 4 timer settings have made it so much better than what i had previously set up for them.The LED's are spaced about 60mm apart, and can be cut at the lines indicated easily every 60mm. Put a USB meter in line with it, and it is drawing about 60mAh so think the batteries will last a pretty long time. The only thing missing on these really, is a dusk sensor, so they will be triggered in the brightest of lights as well during the day, although you could turn them off, or place something over the PIR sensor if that bothers you. Also if you are looking for a white colour, it has no dedicated white LED chips so will be made up using the red green and blue LED's.The APP is very easy to use, and has quite a lot of features that there is going to be something for everyone, if you want some strobing flashing effects or soft colour changing, All in the app. and for once its an app that does not want access to every aspect of your digital life for it to work.

To install....measure the led strip end to end Divide the number and mark the middle with a sharpie. Measure the foot end of your bed mark the middle. Cut the backing on the strip where you Marked and peel one way. Line up the marks and work your way round. One way then do the same the opposite way.Important. Make sure you use the supplied wires for the corners by cutting the strip and using the wires to go across the corners or the led strip won't be long enough. When you cut the strip do not pull the backing all the way off as you won't be able to slide the strip into the connector. You might need to lift the pins slightly with a pin to get the strip in. Works very well but could be a bit dimmer. Perfect for couples so you don't disturb your partner when going to bed or using the bathroom.Pretty much perfect. Installed sensors into bedside units by cutting holes in the back so the top drawer blocks the sensor from the quilt somewhat. You can try doing the same using electrical tape then keep adjusting the tape to get the required height. As this is for a bed it's a shame the sensor isn't covered a bit already as you only need it to detect legs moving not quilts.

Exactly as described, can’t comment on the app remote control but the motion sensor and time modes are great, I have 1 set going up my stairs hand rail and it looks great

Stopped working after a week. Do not recommend.

I had to plug the lights into the mains to make them work consistently. The battery boxes are a complete money pit for batteries. If the batteries get slightly weak the lights won't work. Be prepared to plug the USB into a suitable extension block (with usb slots)Other than that, they are perfect for the under bed, night light effect.

easy to stick and applyi had 40m so they look incredible because i outlined things with themthe app works and so does the remotethey’re definitely worth it

I've put these up the stairs and they were really good for the first couple of days, then they started flashing and wouldn't change colour so I turned them off for a few days, seem to b ok now (fingers crossed) so I haven't contacted the supplier. But they are very bright and have many colour and mode options

Needed sensor lights for my stairs, and this one met my expectations. Highly recommended