BakcouPuncture Proof Fat Tire Liners - Set of 2, Protection Against Flats, Customizable for Various Wheel Sizes, Durable Extruded Plastic Shield for Uninterrupted Rides - 26 inch Fat Tire Bike

Love the product, but what a pain to install, cant help think there has to be a better way to hold in place when trying to get into the wheel. few times I had to walk away as was getting frustrated, but perseverance and it will eventually get into the wheel.

My tire initially wobbled after installing. Turns out this is common, the culprit being that the slippery liner shifts around during install causing tube to inflate with lumps, which cause bulges in the tire side wall, which causes the wobble. The trick to preventing this is, first follow the included directions, laying tire on side with liner and tube in place. However, before putting final side of tire in rim, inflate tube snug enough to lock liner in place, then take your time adjusting the liner so it is perfectly centered. Good luck!

I installed these with the BakCou 26x4 fat tire anti-puncture tubes. No easy way to say it. These are a pain to install. I tried one recommended install on one wheel and another method on the other (taking the tube out or leaving it in) and it’s just a pain. That said I was able to install them and the wheels spin and ride with no bumps or wobble. Living in AZ you need something to protect against thorns, etc. Crossing my finger that these liners along with BakCou tires protect against the thorns, etc.

buen producto

This is one of those things that is difficult to prove it's effectiveness.It's not the easiest stuff to work with.and,Do you really want to ride over boards with protruding nails to prove that it works?My wife has a couple of ebikes that came with ridiculously thin tires.After a couple of repairs, I decided it was time for a major up grade.Went with a larger fat-tire with discernable tread.A thicker tube.and,This thing.So far, the tire has not gone flat.Is that due to the new tire, the new tube - or this thing?The answer is definitively = yes.But, to which degree for which improvement?I can also testify that the liners repel unicorns and big foot.So far, they haven't made it worse.It may take a while before I can appreciate what level of job they doing.Be Advised:Work with the new tires (if you go that route) and the liner on a relatively warm day.The inner tube is pretty manageable at any temperature.Letting the stuff warm up should make the process go smoother.

Tired of getting flats. Live in an area with a Lott of thorns. Recently hit a piece of metal leaving a one inch gash in my tire and tube. Tire was almost new and did not want to replace. Patched the inner surface of the tire with a patch then installed this liner. 500 miles later no flats and the liner is so sturdy that in reinforced the the tire.INSTALLATION TIP:Remove old tube. Clean the inside of the tire with soap and water. Secure the leading edge of the insert with duct tape to hold in place and center the liner, then install the liner. If you don’t secure the leading edge, you will just chase your tail as it will follow as the rest of the liner is installed. Makes the process much easier.As to the length issue that others commented on, this apparently has been corrected. I have 26x4 tires and there was about 4 inches of overlap.

This product is flat and almost impossible to get installed correctly on a curved tire. After installing and uninstalling six times because the tires either wobbled or jumped up and down I finally figured it out. Once I put the liners in the tires and back on the bike, I laid the bike sideways on two 5 gallon paint cans. While the tire was still on the bike I deflated the tube and removed one half (one side) of the tire. I then put three fingers inside the tire so I could feel the liner and as I rotated the tire little by little I used my fingers as a guide to push in or pull out the liner until I could rotate the tire and the liner was even all the way around. This product really does work if you follow my install instructions.

Mostly the liners stops minor flats from thorns, but industrial staples and nails or screws not so much. Will be looking into another option to keep getting flats, I would like to be compensated new tubes

Mais sûrement moins de crevaison

Il manque du matériel et pour ma part j'ai installé le tout malheureusement qu'en j'ai changé et réinstaller le tout j'avais mal ajuster le tire qui fait que sa brassait comme une roue fausse mes se si était du a ma faute je retourne le produit pour le manque de matériel

Looks as ordered