Klipsch RP-140SA Dolby Atmos Speaker

Awesome looking speakers with out the black grills onSound awesomeSit perfectly on top of front speakersCan’t fault them

Amazing atmos speakers my whole system sounds completely different, highly recommended. The atmos is AMAZING.

They finish off my surrond sound system, very happy

Good speakers, not very cheap for small speakers but Atmos is expensive.Be aware that the Atmos effect is only noticeable is specific scenes (such as rain).I recommend to buy the front speakers RP-280-FA where these speakers are included instead.

La marca es una garantía de calidad en construcción, diseño y calidad de audio; el modelo en especial, ofrece una gran mejora en la configuración para Dolby Atmos.

Really impressed.I have a 5.1.2 system but will probably upgrade to a 5.1.4 (4 Atmos speakers: 2 in-front and 2 behind shooting upwards) I had a previous Atmos speaker and upgraded to the Klipsch model, since I have all Klipsch speakers. (That way I can have matching speakers and timber matched) You can still add them to any other set-ups, it was my personal preference. The first thing I noticed was that the speaker sitting on top of front towers, didn't push themselves back like my older ones. Since this design shoots up to bounce from the ceiling, it doesnt shimmy backwards at higher volumes. Stays perfectly in place. I purchased this on January 2nd and now ( Feb 14th) making the review and has not moved an inch.1. You can hear the added dimension.2. Clear sounding and the spread effect is pronounced.3. Effect can be hear if you have the proper room layout and not to far away from sitting position.4. They can be used as height speakers OR Dolby Atmos set-up.I wanted to address something first. Auto calibration systems in receivers can be off (most are not perfect and sounds does reflects throwing the auto-calibrating system off) its recommended for you to adjust based on how everything sounds in the room to your own preference. What I do is auto calibrate first for distance, if distance comes out correct than adjust the "gains" in the receiver settings (the volume each speakers) Some systems put the volume lower, which makes it harder for sound to reach the ear. Most room set-ups use a microphone and the mic might be overly sensitive and set the gains (volume) lower.If you hear the effect or the extra layer of sound, you're done.You may want to increase it higher in case the receiver sets the volume lower. Just take into account Atmos is an extra layer of sound, its meant to be atmospheric, with the occasional raining down effect of a film combined with back and front speakers creating a sound bubble. The extra layer of sound can be hear by simply switching 5.1 and back to 5.1.2 in the receiver in a film that supports it. Sometimes things are recorded as objects. Its not all a rain down effect.Most, if not all 4k films are remixed in Atmos or DTS X, with some blue-rays non 4k films having it included (Most the times its the standard audio set up for 7 speakers) but receivers that support Atmos and DTS X have an up-converter, which simulates the effect and can be heard, just remember that films encoded for it obviously sound better.5.1 sound an higher will still be up converted in the receiver, even if the sound playing lacks the Atmos or DTS X encoding. All my games and older films have an extra layer of sound, filling the room that even my own father noticed it was crystal clear (from the smallest bullet, to the effects or basic front sounds).What I would recommend, play the test tone in the receiver after the auto-calibration. Some default to higher sounds pitch, others, you can increase the volume to what you normally set it to, as the test tone plays adjust + or - of the individual speaker. Increase or lower based off your own personal preference, but allow it to match the other speakers test tone pitch. Don't over drive it. Some prefer a slightly higher pitch for Atmos speakers. In my set up, its increased to +3 vs +1. Even in audio forums some suggested to set it higher 2-3 from the default set up. Remember, if the default sounds fine, than you're done. But never hurts to tinker with it.Take into consideration that the Atmos speakers are not always 100% on, it's based off how the film was recorded. When I use the basic up-converter on the receiver from non Atmos/DTS X encoding it tends to be more active because its creating a simulation from a non encoded sound file. Try NOT to be far away from the main speakers, or have a massive vaulted ceilings. If you have vaulted ceilings, its better to hang them on the wall aimed down, and turning the receiver into 'height channel' vs Dolby speakers. Its a speaker set up that directs the speaker into the seating area vs up and down. The receiver will than auto adjust itself.

Good quality speakers. Good choice if you can not install ceiling mounted speakers for Dolby Athmos experience. High priced compared to front floor Klipsch "tower" speakers.

Venant de changer d'ampli pour un compatible Atmos, je cherchais des enceintes compatibles. Le reste de mes enceintes étant des Klipsch Reference, je me suis tournée vers cette marque pour l'homogénéité du son.Le prix est assez étonnant au point de me demander s'il y en avait bien deux dans la boite. Très belle finition avec le logo Atmos sur le cache. Le son est très bon même si j'ai besoin de plus de rodage pour me faire un avais définitif. Certains prétendent que le sont vient du plafond mais c'est encore un peu flou pour ma part. Il y a une spacialisation bien plus importante c'est évident mais je dois peaufiner ma configuration.En tout cas je suis très content de mon achat. Merci Amazon pour le prix imbattable.

Wer auf die neuen Soundformate a la Atmos setzt, fängt sicherlich auch mit den Onkyo Brüllwürfeln an ... habe ich auch (weil sie gratis waren oder die zunächst günstigste Lösung). Nun sollte mal was passendes her, das sich besser die in die bestehenden Lautsprecher einfügt, in meinem Fall Jamo 628 plus Sub J12. Es war zunächst ein vorsichtiger Testkauf, da es sich noch immer um Effektlautsprecher handelt und ich mir kaum Unterschiede ausgemalt habe, plus dem Umstand, dass Atmos Filme ja noch recht übersichtlich sind. Was also rechtfertigt da 500 EUR?Tja, man muss es tatsächlich hören. Ein Unterschied wie Tag und Nacht. Atmos Effekte kommen deutlich präziser und klarer herüber und können wie erwartet über einem wahrgenommen werden. Over-Head Ceilings sind damit absolut nicht notwendig. Das Ergebnis überzeugte auf Anhieb so, dass ich die Lautsprecher auf jeden Fall behalten werde. Die Kosten dafür sind zunächst zwar etwas hoch, zahlen sich aber in jedem Fall aus. Verarbeitung der Lautsprecher ist natürlich hochwertig, was man bei Klipsch wohl kaum erwähnen braucht.Versand und Abwicklung via Amazon wie gewohnt top und schnell!