OEM Rear Cover Back Glass Replacement for iPhone 13 pro max 6.7 inches (Graphite) All Carriers with Pre-Installed Adhesive and Repairing Tool Kits

perfect

The replacement is plastic NOT glass. The tools are worthless. You will spend 4-6 hours on this. My first one and without any incidents. I used the flat pry bar until my fingers bled. Get some quality tools that you can keep when you buy this. It’s not a bad kit it’s just intense. Around the lenses is super complicated and need to have some wits about you. Must buy and center punch to get the glass out of the lens area. Stop frequently and clean the area. Get some glue to seal everything before sticking this on. The adhesive does nothing except hold it in place, very open. Not even water resistant using the adhesive alone. I used clear JB Weld Resin. Biggest relief was using tape to cover everything that you’re not working on so you don’t get bloody hands like I did. The glass thickness around lenses is double thickness. Understand what is behind the glass before digging, there is loose magnets that come out, there is delicate copper coils, the antennas, flash, sensors. All of this is sandwiched between the phone and glass, you dig in without knowing…you lose, 100% guarantee-kit-quality tools to pry and several Exacto blades-small heat gun-center punch-time-don’t drink liquor, won’t go well

complete garbage I bought two thinking the first one just wasn’t good but no is the quality of everything starting with the glue it comes with first one broke when being install it cracks easy and second one the glue doesn’t work by the very next day it was open again don’t buy it’s cheap for a reason

There’s nothing wrong with the product it worked great, but let me tell you I don’t advise tackling this job unless you’re very patient and well prepared. The glass is really thick around the camera lens and super hard to get off. I finally did but I ended up damaging the front screen And killed some pixels so I had to end up replacing the front screen on a iPhone 13 pro max. The worst part about the whole thing is that screen cost me 450 bucks and I was so frustrated. I just brought it in and had somebody do it so the total cost me 550 for some reason the iPhone 13 promax the parts are more expensive than other phones , it’s probably the same way with the 14 promax when I brought it to the shop the guy had a special laser that he ran over the phone which loosened all of the Apoxsee glue and it came right off. He did the repair in about 20 minutes it really matters to have the right tools , the right desk top setting this is truly something to consider before you try to repair it for yourself

The product came defective but the color was on point and I will do a review after installation.

Most of the bad reviews that this product has is about user error, if you take your time, and I mean TAKE YOUR TIME, it’s very possible to do. I have already had my back glass replaced by a different store so I think that made it easier for me to remove the adheasive. (Maybe the adheasive wasn’t as strong as apples) The camera spot is the hardest, but for me it was pretty easy because my glass was completely shattered and had cracks near the camera so mine lifted relatively easy. All this to say, my experience was probably easier than most, but the result was very worth it!

Fixed the phone

Cons: I can see visiable gaps arround the Camera lenses. Not very confident that it will provide any IP rating anymore.Pro: Cheap and easy replacement.Suggestions: keep your device away from water. It can easily harm the device.