Ender 3 Heated Bed with Cable 24V 220W Compatible with Creality Ender 3, Ender 3 Neo, Ender 3 pro, Ender 3 V2, Endder 3 V2 Neo, Voxelab Aquila X2 3D Printers

Works great! Easy hookup no complaints

Normally to lazy to write reviews but will on this. looks identical to original except has the stick on pad for the bottom side to keep heat in and seems to distribute heat more evenly. am happy with it easy install and leveled perfect. I would suggest this to others after original warps to point it messes up prints.

I was having a heck of a hard time getting things to stick to my old bed. eventually degraded all the way to using a non-contact thermometer and found I had a spot or 3 that were as much as 5°C colder than the rest of this bed. anyhow, this replacement was a perfect direct fit for my Ender 3 printer. I ended up adjusting the temperature down in my slicer a bit... more proof that the old bed was having issues. I'd reccomend this build plate.

After trouble shooting for weeks on Abnormal Temp failures on a S1 Pro, I finally cut the bed wire sheath apart and found a broken ground wire on my original bed. Outside of wire sheath looked perfectly fine but after removing sheath I finally found the problem. This bed is plug and play except it doesn’t have a ground wire. I drilled the back edge (where my original was) being careful not to drill into the heating area. Then I threaded it for a 8-32 tiny bolt. I also added insulation to the bottom of the bed and ran the wiring through some loom I already had. My printer is up and running again. I’d give 5 stars if it came with a ground wire and a beefier bed attachment to the bed.

This is not official by quality. Works so far. Doesn't heat as fast as the official bed. Wiring is thicker and doesn't fit the slot. Had to trim and redo the wire to make it work.Good low cost replacement

Broke the plug on my original bed plate when trying to install an upgrade. (Didn't realize it was glued to the board 🤦) Had the new bed installed and back to printing in about 15 minutes. Temp was spot on and performance was excellent.

What I need .