303 Vinyl Convertible Top Care Kit, Blue

Bought for the vinyl tonneau on my Chevy pickup truck. Works very well, good stuff

Probably made a mistake with previous cleaning solutions I have used twice before this product is used, and if I would started straight with this cleaner, maybe it could be better. Read and follow instructions. More water on the soft top before applied cleaner is better. I washed my after rain.

I ordered this kit last evening and it was delivered this evening. I was excited to try it based on all of the positive reviews I had read. Most reviews were regarding convertible tops. My application is for a soft tonneau cover on my Jeep Gladiator.Unfortunately, my Jeep is parked outdoors, mostly. Even more unfortunate is the exposure to the oak trees. The amount of mess that oak tree’s cause on a vehicle is frustrating. My tonneau cover gets dusted with pollen, speckled with fallen leaves and peppered with the other miscellaneous junk that falls from these trees. Needless to say, the tonneau cover typically looks terrible. Until now!I quickly went to work with the 303 cleaner after reading the instructions. I rinsed the cover and applied the cleaner. I did scrub it onto the tonneau cover with a soft bristled brush and let it sit for about 5 minutes before rinsing thoroughly. Wow! What a difference! I dried the cover with a microfiber towel and ensured it was completely dry.I applied the 303 Protectant by spraying it onto a clean microfiber towel and applying to the cover as a first pass. After wiping the entire cover, I sprayed a few bursts directly onto the cover and wiped it onto the cover as a final coat. I’m impressed! I would surely recommend 303 Cleaner and Protectant to anyone looking for a great product for such a purpose.Hopefully it holds up to the sun, heat and rain. Perhaps I’ll update my review after a few months, but so far, I’m extremely happy with it!

Both products worked beautifully I loved the way the roof looked new again.

I never got to use the product because both bottles had 3/4 of their content spilt on the way to me and the bag was full of the fluids with the box they were in soaked

Works great. Top looks black again. Buy the special brush too and you are all set!

Very impressed and will continue to use. I read a LOT of reviews and figured this is about the same quality and ease as the RaggTopp product for the same purpose. The only reason I went with 303 is because it has more stated uses (basically anything plastic and then some). I will pass a few tips along for applying to a convertible top. The cleaner works great, just follow the easy directions. You don't really need this particular cleaner to clean the top, but it's cheap with the kit. Tip: Use a VERY soft brush or non abrasive sponge to clean all tops, no matter the soap you use. When drying, use a chamois towel by draping over areas, remove and wring out, drape again, until dry. A regular towel works to dry but not as easily. Dry down in the cracks where the top tucks into the frame (usually just push a little into the crack, nothing too forceful). Don't worry about overspray with the included cleaner. Dry in the sun if you can -- just make sure it's dry. Now onto the vinyl dressing. Some people put plastic all over the car to prevent overspray, which will certainly work but seems like overkill. If at all possible, do this step inside the garage. Temp must be at least 70 deg. I recommend two microfiber clothes to take care of the process (size of a wash cloth, roughly 12x12 inches). A similar size piece of cotton t-shirt can substitute for the microfiber, but use a bigger piece of t-shirt if that is what you dry with. If you squeeze the spray bottle SLOWLY, it will come out without spraying everywhere (assuming inside a building). Don't spray near the edges of the top. You can spray directly on the top, or spray into the applicator. Always spray into the applicator cloth if doing this outside to prevent it from going airborne in a big way. Again, spray SLOWLY. I believe the key is to work in an area approx. 15x15 inches: wet it, then dry it. Spray on, spread with cloth, or spray on cloth and wipe on, then use other drying cloth to dry. Repeat until done. Around the edges, windows, front of top, etc., always spray on the cloth and apply so no overspray occurs. The applicator cloth becomes soaked after a short while, so it's easy to use it for detail work without having to spray into it constantly. If you accidentally spray the paint or window, simply use your drying cloth to wipe off. You don't need crazy protection from overspray if you simply get it off before it dries for a while. If you really want to be particular, have a bucket of soapy water and sponge the overspray off. But if you are careful to begin with, overspray isn't a big deal at all. I have done it with success on my Miata, and it only took about 15 minutes of work for the dressing. And I was quite picky to get everything perfect. And when you are done, use this stuff on all the seals around the top, windows, doors, etc. They recommend wiping it on and let it sit for about 5 min before drying. I used the same microfiber cloths after I did the top since it's much dirtier work. And if you have even more time, use the stuff on the entire interior plastics.