ForgeFix Chemical Anchor Resin - Styrene Free | 300ml | Grey | Per 1

Excellent product. Use standard bath-sealant gun (some of these resins need special guns). Extremely strong, but sets very fast (a few minutes) so have everything well prepared beforehand. I've used it a couple of times for yorkstone step edgings that had come loose from their (cement) bedding.

This product was used for anchoring threaded rods into block. I had prepared all 10 holes which were 12mm x 50mm deep as I had previously read that it was quick drying. I half filled all the holes and then put in the rods. By the time I got to the last two it was set. So I had to drill the resin out and re-do them. It works well but it was set in about 5 mins. I would probably recommend doing 1 at a time to ensure that your fixing is going into the wet resin. Also I recommend that you don’t use the first couple of squeezed out resin as I found it hadn’t properly mixed. It’s excellent stuff but just keep these things in mind if you choose to use it.

Product is fine but virtually impossible to get out of the tube

Worked well

Do not buy this product, absolutely useless. If you insist on buying it invest in several of the special mixing nozzles as it sets in there quicker than it can come out! I wanted it to anchor some studs into the ground to hold a shed to a concrete base, the stuff is absolutely useless and as another reviewer has already said there are cheaper better alternatives out there that have a much stronger hold than this rubbish. Rip off price for a poor product, avoid at all costs.

Goes off faster than spec suggests. Not an issue for the work I was doing but could be problematic.Very strong bond.Would use again.

Waste of money. It broke my sealant gun as it wouldn't come out of the mixing nozzle

Avoid. There are better and cheaper alternatives