MAHDPRO Metal Desk Grommet 2 Inch (50 mm) Pack of 2-Bronze Zinc Alloy Metallic Desk Cord Hole Cover to Arrange Cables & Wires Through Computer Table/Countertops

I, unfortunately, had to cut a hole in my countertop for a plug during a new water filtration install. It would've been too much trouble with the way my old house is setup to run power under the sink. This made the power cable routing look extremely clean. I don't even notice the power cable next to my coffee maker.

Look great. Matched with existing cabinet knobs. I did cut the hole 1/16 of an inch smaller than the recommended size and got a nice snug fit. Ran a larger guage power cord from a surge suppressor, a HDMI and a Ethernet cord through the hole with room for one maybe 2 more smaller cords. Very happy with the quality and look of these compared to plastic ones I have seen

These are sturdy and beautiful. They do not look cheap at all. The reason for the 4 star is that they are not true to size but slightly smaller. However, I saw a comment where someone added command strips, I did the same and it worked perfectly. So if you’re ok with that work around, I say order them.

Worked as advertised

I recently installed an equipment rack for a few network-related pieces of hardware and some network cabling. The rack needed a couple of holes in the rear for access to cables coming through the wall in my new home. For primarily aesthetics, I decided to use a desk grommet to provide a finished look to the new holes and also to ensure that none of the cables (network and power) chaffed on the somewhat sharp edge of the hole. Since these grommets are 50mm in diameter, they are actually slightly smaller than 2-inches, a small amount of adhesive fixed them firmly in place. I didn't use the insert, but they snap into place firmly if needed for your application. Overall, a quality desk grommet at an excellent price.

I purchased two of these grommets to elevate the look of my husbands desk. Instead of using plastic grommets, I chose these to hide multiple wires.

Came in perfect condition and installed right away with no problems.

It looks nice seemingly sturdy material, but the hole on my desk is 2", and the flange, which is the top part I'm referring to is 2", which makes it fall into the hole. A flange should flair out more to prevent it from falling through. As you can see, the flange is at 2", and the fitting that goes into the hole is about 1¾". So, this isn't manufactured to the correct size to fit in a 2" hole.