POWERTEC 71119V 36 Inch Double-Cut Profile Universal T-Track with Predrilled Mounting Holes, T Track for Woodworking Jigs and Fixtures, Drill Press Table, Router Table, Workbench, 2 Count, Pack of 1

Good quality. Works well for my project

I needed more of this to complete a very useful, beautifully executed (brag, brag) router table fence setup in the side extension of my table saw. It will be excellent for general purpose, but I made it for running some custom trim, with some extra custom work holding/feather board jigs. Fun project and came out nicely.My general caution is to be sure to thoroughly read the product description to be sure you're getting what you need. I did a "Buy again" from a previous purchase of tracks that were almost 48" long. These came 36" long. I went back and, sure enough, the description said 36", so it was honest, but it wasn't a "buy again". Turned out this length worked perfectly for what I needed, but beware when ordering stuff.

These tracks were easy to install and work fine.

Ordered this kit to go with separate order of T-track. This are regular bolt heads and fit in the track, slide if held perfectly straight, but feel rough.The knobs are decent and the kit will be useful, but I will order bolts with t heads for my application.

This POWERTEC T-Track Knob Kit is a great cheaper alternative if you already have clamps and just need the knobs and bolts. The quality is solid, and they work perfectly for woodworking jigs and fixtures. Highly recommended!

The media could not be loaded. I installed these into an updated work bench that I renewed with a piece of 3/4” MDF. If using router take multiple passes increasing the depth slightly each time. I highly recommend recessing the T-track 1/16” below the work surface so you don’t have any interference. Always order more than you need as you may have to cut it to fit your design as I did. The intersection pieces fit perfectly with no gaps except for my errors.By the way, I used a leftover piece of T-track on the back of my bench to hold my clamps. As can be seen from the photos the clamps aren’t the same color as the T-track but they do the job.I highly recommend this less expensive alternative to other makes of track.

Work as intended, 'almost' too small for the rails on my kayak but they work.

Good value T-track; straight, nicely machined, nice anodized finish, fits standard fittings well.