ST5253

Used on several of the micro connectors and it works well.

I ordered this primarily for the Micro Timer terminal tool, I have several JPT tools and various other cheap terminal removal tools. None of the cheaper tools I have actually fit in the Micro Timer housings, I had to use two small single prong tools which was tricky to do. I did have to put a slight bent in the prongs near the end to push inwards on the locking tangs of the terminals, but It was actually pretty difficult to do with a quality set of needle nose pliers. All in all these seem well made and well worth the money. Five stars for a good value.

Bought this set mainly for the Mini-Fit Jr. Extraction tool for ATX and EPS connectors.There are a few of these pin removal tools on the market and a lot of them carry the same poor design; two pieces of flat metal separated by a spacer. I can say from experience while you may be able to get those to work, they are flimsy and hard as heck to use.This Jready set is not flimsy, they have a good holding base, and the tips have an angled edge that helps depress the metal pins when inserting.All in all, best Mini-Fit Jr. Extraction tool I've used in over a decade.

Ended up returning them ...bought on the recommendation of a review that they work for Audi/VW ...didnt work on my 03 VW ..so had to return them ... probably work awesome for their intended purposes..

Works great for de-pinning popular automotive connectors.

I purchased some Molex Micro-Fit 3 connectors for my 3d printer hot end. I need to pull the old connectors crimp new connectors and attach a new connector. Step one remove old connections, well this did not happen. This tool is better than some of the cheap tools made of flimsy metal. While the quality is better the double-prong design did not work at all. Very disappointed, and since I pushed and wiggled so much to try and make it work the extractor tool DRK-D120P for female connectors is now bent.After working with JReady they found a tool that works better for my application, the JRready ST5262 Ejector Rod Pin Extractor. They were very helpful and the ST5262 is a great tool.

I struggled to get pins out of my Bosch / AMP connectors using a flimsy tool that was one of 31 for $15, because the tool would bend before it released the connector from the housing. The right tool slipped easily into the slot, and with modest pressure I could feel the click when the pin was released and I could slide it out. This little set was worth every penny.

Works nicely for removing molex pins which is what I purchased it for. Just make sure you use the right sized one and they'll come right out.