Generic Pack of 2 Carbon Filters Compatible with Belling and Stoves Cooker Hood

Generic replacement filters that are a fraction of the cost of branded filters. Exact match and very easy to fit.

The Belling originals for their cooker hoods cost a fortune but these, or the one from espares or spares2go cost well under half the price and do the same job as far as i can tell. I bought these for the first time in April 2016 and on inspection they seem to weight the same as the Belling ones (about 185g) and will therefore soak up about 50g of oily yuck during their life. At this price you can justify changing them a little more often but probably never as often as Belling would advise you too. I do mine every 12-18 months rather than 3-6 as Belling suggest.I have also just bought some compatible types from espares so if you see nothing else add here from Sept 2016, assume these worked fine and buy them instead of orginals.Also, if you try to find your exact make/model listed in the 'this is what it fits list' and you cannot find it, take you old one off and measure it. If the two round surfaces are 190mm (larger) and 170mm (smaller) and the thickness is 38mm, then it should fit just fine but, before you commit, also check that the hole in yours (centre) looks like a wingnut, i.e, a circle with a matching protruding knob top and bottom. If it has, take the risk. My model Belling wasn't listed and these fit just fine using the advice given above. Good luck!

good item at a good price

Bought for a CDA (who?) extractor fan and help to reduce (don't eliminate..) cooking smells of recirculated air in open-plan kitchen/dining room. Absolutely fine. Don't know life expectency but I found in the past you can maximise it by replacing paper (grease) pre-filters more regularly and giving the charcoal a shake periodically to expose 'clean' surface.

These did not fit my Bush hood

Items states it fits Belling cooker hoods but on delivery the item was too big.

Had to modify to fit my extractor but seems to be doing the job!

These are advertised as fitting stoves cooker hoods. However they dont fit my 110cm Hood.When u called Stoves/ Belling customer care the confirmed mine are a different type.So instead of paying thier £45+ price for the correct ones i have simply modified these to fit by cutting out the centre to the correct diameter and pushing them over the clips on my hood fan.