5PCS Screen Protector for Anycubic Photon M3 Max, M7 Max, Resin 3D Printer 13.6'' Screen Protective Film for Photon M3 Max,M7 Max 13.6'' LCD 3D Printers

Bought to replace a well-worn factory protector. Went on well and does the job.Recommend re-leveling after replacing just to be on the safe side.

I wish I had checked earlier. Purchased these to replace film in Halot Mage Pro, when needed. Needed it this weekend. They do not fit. In addition, they are the the improper material. Too late for a refund. Buyers beware these are screen protectors

These screen protectors fit the Mars 4 Maxwell and protect against resin spills and scratches. I bought the Saturn size because the Mars 4 Max ones were undersized, so I went by screen size. The clarity is good, and having five in a pack is a nice bonus for future replacements. I did go through one to figure out the installation.However, they tend not to stay stuck very well, which is frustrating. Even after careful application, edges start lifting over time, and dust can get underneath. It does the job, but I expected better adhesion.

As soon as I applied these protectors, my prints have came out horrible and massive failures. When I took it off, my prints were perfect as they always were. Horrible product

They do their job, but not very well, applied correctly, but with very little instructions I had to waste 2 before I could get it to work right, also they list as 7.6 inch LCD screen protectors for M3 Anycubic, yet the box says 6 inch and they are a tad bit small, but work in a pinch