FMKFMK kitchen worktop square end cap q3 profile, 40mm high, black 3mm radius

It seems to be impossible to buy anything other than end caps for bull nose worktops in the DIY sheds, which is pretty useless if you don't have bull nose worktops but still want end caps. I was concerned by the product description describing them as both "square end caps" and "q3 profile" (I thought square profile worktops didn't curve at the front), but upon receipt I can confirm that these have the 3mm radius curved corners that match "q3 profile" worktops. Once fitted, they look much neater than the usual strips of laminate that get glued on and slathered with coloured filler. Should last longer, too!

Looks a good product.Yet to be fitted.

Yes just the job for tidying the cut bed of the work top

Came well packaged although screws could have been in a small bag. Looks good although I managed to scratch some of the black off while fitting a stainless steel backsplash, but would happily replace with the the same.

Just the job for the end of the work surface - it covers where the strip end has broken away and because it is an older worksurface it is harder to find a trim to replace - this will be stronger and more fitting.

Does the job, I just cut it to the correct length with a hacksaw and used black screws to attach to the end of the worktop.

This was not the size I wanted, that appeared almost impossible. It was easy to cut to size. I had a 22mm (h) worktop.

These ends are really useful fitted to the ends against the Stove, preventing any problems as the range is moved in and out of the space.