LUYED Auxiliary Back Up Parking Reverse LED Light Bulb 1200 Lumens 6500K White 3020 6-EX Chipsets Enhances Night Performance Tail Light Camera Illumination for Car Automotive

This is a great little light. I used it to replace the factory single incandescent interior light in my truck cap, which was very weak. Because of the lense design, this single light illuminates almost the entire space; the ceiling and corners near the tailgate are the exception. As someone who does off roading and camping, this light is compact and bright enough to serve several purposes: under hood lighting to illuminate the engine compartment, under chassis "rock lights" for navigating rough trails at night, roof rack mounted lighting to illuminate area around truck or campground. I wish it had an option for routing the wire out the back of the housing to make a cleaner install. Aside from that, it's a great light. I hope it has a good lifespan.

This light is amazing! I purchased it to compliment some LED underglow lights (xprite pickup bed lights with custom extension cables, 5 pods per side). I needed something to light the front of the trailer so nobody would put a shin into the hitch coupler at night. I mounted this to one of the battery support cross bars, facing forward, and tied it into the switch for my other under glow lights. This baby puts out some serious light! I'm now wishing I would have just bought 10 of these and used them for undercarriage lighting instead. I don't know how much power it draws but my 30 1.5 watt LEDs under the sides of the trailer run right alongside this unit without popping the 5amp fuse so draw can't be much. I installed 4" rather large LED flood lights on top of my rear RV bumper as backup lights and in hindsight, 2 of these mounted discreetly underneath the bumper would have done a similiar job. I may end up swapping for a pair of these if I have any issues with the flood lights. I did notice the metal housing gets rather warm during extended use whereas my other LED lights generate no heat at all. I like that the housing is metal but do worry about the heat buildup if run continously. We'll see how it holds up this camping season, but right now I'd shy away from mounting it to a wood or plastic surface just to be safe.

Very bright, very small placement, use, and a lick of paint/sealing will make them last

Install this on my 2011 Acura MDX and it works great. Now when i back up in the dark my screen is able to see more. Installation wasn't that hard for the MDX but the only thing is i wish the cable that came with the light was a little thicker. The thin cable made it harder to crimp the wires but overall not too bad. I did use both double sided tape and screws that came with it. The double sided tape is very strong but i just thought it would be more secure with the screws. The only bad side is, i had to drill two holes on the plastic housing on top of my license plate. Overall i would recommend this product.

After installing a backup camera on my Altima, I discovered that the OEM backup lights were on the dim side. So I looked for a solution. PROS: -Very bright. Even tho I'm using two, (1) would have probably been enough. These even help at Dusk. -Nice low profile. They are barely visible mounted at the top next to my license plate lights. -Not adjustable. This may sound like a Con, but I didn't want the extra height of an adjustable model nor worrying about the adustable bracket coming apart. For me, the low profile is great. -Did I mention how bright these are!? CONS: -Wires aren't very long. If your mounting location is on the body vs the trunk lid, and not too far from your Backup lights...you'll be ok. But I wanted to mount these on the underside of my license plate housing next to the license plate lights, which is on the Altima's trunk lid. And the wires had just barely enough length to reach the wiring going to the Backup lights on the body. 6' sounds like a lot of wire until you have to route it thru the trunk lid, past the hinge(leaving enough to flex with the movement of the hinge), and then back to the Backup light wiring near the fixture. I traced the wiring to as close to the hinge as possible, but it was just barely enough to make it. I would suggest adding 2-4' to the wiring provided with the lights. You can always shorten wire, but adding wire can end up being problematic in the future.. -Power wires are very thin. I would prefer it if the wiring was a little thicker gauge. Would also prefer having a different kind of insulation. The wire insulation was difficult to safely remove due to the small gauge of the wires. It's a molded type vs a sheath style. In order to connect the wire to the Ground and Backup power wires, I needed to remove about 8" of insulation. -No Protective Grommet or Sealant where the wiring emerges from the light. There's just a hole where the wiring exits the light, thus alowing dirt and water to enter and the wiring to rub against the metal. Eventually either water or road vibration would cause a failure, so I sealed the hole with Outdoor RTV. This caused me a 24hr delay in installation to allow the RTV to fully cure. Overall, I love these lights. They work great, would buy again..even with the Cons. I've had them for 3 months now and no issues.

These lights are CRAZY bright, I am shocked and so happy with the color temperature. They look amazing. Initially I had purchased 2 and both happened to be faulty (I’m guessing a bad batch) i contacted luyed and they quickly refunded my money which was great, but I still wanted to try these out so I decided to get another because I like their design and style, and WOW they didn’t let me down. I’m going to buy 6 more! The color temperature is PERFECT 5k they aren’t that gross 6k that has a slight blue hue to it. I like pure crystal white and these fall nothing short of it, they are so damn bright it’s hard for me to believe it haha. I can’t recommend these enough, I’m going to make a YouTube video on these, that’s how much I like them. MaxxxPayLoad is my YouTube channel I’ll be uploading after I order 2 more and install them. It should be in the next 2 weeks.

I hooked this up on my jeep..cause I blacked out my taillights..and couldn't see things when I back up. Through the camera...great little light. Easy to hook up..very happy with it..only bad thing wires are really thin..other then that..it works great

The first unit that i received had some damage to it. I contacted Luyed customer service, and sent them pictures of the damage, they took care of the problem. Very happy with Luyed customer service!! Thank You. The only cons is the thin wires. I had to put solder to the tips to make them thicker just to be sure of a good solid contact. Happy with purchase!

This thing is bright for the size crazy

worked great for around 3 months. then died. you can see the LED looked like they are burned out. maybe they are no good in cold climate

Very bright, perfect, but 2 units both stopped working in about a year. The photo shows something on the inside of the glass. The cable entry is at the back of the unit and does not appear to be sealed, a basic error for an exterior item at the back of a vehicle. Note the white around the cable entry. It now says "inside" for fitment which is ridiculous.

Tinted windows are great for keeping out the summer sun, but reduce visibility in the dark. Installed this on the license plate light bracket. Definitely lights up the area behind the car when reversing. Happy with the purchase.