Question 1

what is the total width including the mounting brackets? mounted vertically

Accepted Answer

I just measured both of mine...to the outside edges of the wall mounting 'plates', the total width is approximately 28" (meaning the 'width' to mount the brackets will not line up with the wall studs).  Because these mirrors are fairly heavy and the 'tilt' (which increases the stress load on the mounting brackets/pivots), the wall mounting brackets cannot merely be anchored into sheetrock/drywall.  Once I knew exactly where my wall mounts were going to be located (vertically and horizontally), I used an oscillating saw and ripped-out a 5" high by (width required so that the ends of this board could be anchored to adjacent wall studs 'wider' than the width of the mirror) piece of the drywall.  Then I ripped (on table saw) a piece of pine lumber slightly thinner than the thickness of the drywall and used drywall screws to anchor it to the wall studs.  Once anchored, I pre-drilled the holes I needed for the 2 mounting brackets and then 'test fit' the mirror to ensure everything was lined up properly.  I removed the mounting brackets but then put similar diameter, but longer, screws back into the holes and let them protrude from the wall.  Then used drywall compound and fiberglass bonding screen over the board and adjacent drywall, let it dry and then built up the drywall surface over the board so that it was uniform with the wall.  You can finish the wall then as you desire (I tiled mine with travertine mosaic tile), then removed the screws from the wall.  Now when you go to mount your mirror(s), you have a solid 'base' for the screws/mounting brackets and mirror installation should go smoothly.  Actually mounting the mirrors to the brackets is a 2-person job (one to support/hold the mirror in place and the other to tighten the pivot brackets.

Question 2

Can this mounted horizontal?

Accepted Answer

Yes, this mirror can be mounted horizontally.

Question 3

Will you be getting the bronze option back in stock? if so, do you have an eta?

Accepted Answer

Thanks so much for your interest. We actually have some on the way to restock. They should be back to purchase in about a week or 2. I'm so sorry for any inconvenience and thanks again!

Question 4

Is the mirror beveled?

Accepted Answer

Hi,

Thank you for reaching out. Yes it is beveled, elegant  oval mirror.

We hope this help!

About Us

Customer Services

Customer Support

Regional Access

Legal & Policies

Social

Get the App

Hamilton Hills24x36 inch Frameless Oval Pivot Wall Mirror with Black Rounded Wall Brackets | Large Circular Tilt & Pivoting Bathroom Mirror | Bedroom, Farmhouse Hanging Oval Wall-Mounted Vanity

Description

Have a Question? See What Others Asked

Common Questions