Newsun – 3W High Power LED Light with Screw for Car/Bike – Additional Parking/Reversing Traffic Lights

One of the units had a damaged thread such that the securing nut would not easily turn to the lamp end to clamp the light to the Bulkhead fitting.Both units have silicon sealing where the wires enter fitting that had been spread over onto the thread, meaning that when the nut was removed to attach, the seal was broken allowing the possibility of water ingress in to the lamp fitting.

Be warned they are extremely hot after a short while 1/2 hour tested on a bench the lamps to 100 degree c so be careful wear and what you fit them too and also if fitted to a place a child could touch them they will have 1st degree burns for sure i have returned mine due to this. Also if yiu look at them for jut a few seconds you will get black spots in your vision so be careful as you may blind others in front of you. My picture shows a reading from the back nut and front lens. You have been warned

Used on a monitored CCTV system to indicate when system is set/unset.Can even be. Seen direct sunlight.Useful and now a must have item for a security install Engineer

LED’s feel like a quality product. I installed 2 of these as reversing light aids. Bright enough not to need anymore. Now my daughter wants a set of LED’s on her car as an aid. Easy to install 10mm hole. Fitted with back but. Included.

Have 5 of this drilled into a alloy plate on my street fighter and they are really bright and look good

Very nice but a little too bright for what I intended to use it for

I bought these to use as daytime driving lights and am delighted with the quality and reliability. I fitted two to each side at the front, which is more than enough. The other 6 I used to light my aquarium using a 12v transformer.

Good quality, good length of wire as well very bright