AC17VX2 600mA for Mixing Console Mixer Power Supply AC Adapter 3-Pin Connector Plug for Yamaha MG16/MG166CX/MG166C/F4/F7/6FX/MG82X,Connector Pedalboard Power Supply 17V 600mA,110V-120V Input US Plug

Works on a Yamaha MG10XU mixer. No issues. Gets a little warm, but it has vents and that is too be expected. Can't speak to longevity, but so far it seems sturdy enough. Packing was not fully glued and arrived somewhat open, but the product was undamaged. All in all, happy with my purchase.

My friend Micheal Shown gave me an extra mixer. He said he included the power cable, but I thought he didn’t and I remember him saying that his sister had the charger. Nick took me home from Micheals house after band practice, and I didn’t leave it in his truck. Nick said he cleaned his truck and didn’t find it. Anyways I needed a power supply and this one does the trick! I can’t wait to start recording my outerspace sci-fi’s 1940’s style country album about living is Roswell New Mexico! Yeeeee Haw! And beam me up!

Great 30VAC step transformer. Wired it into an old tapeco mixer I wanted to use, still going strong 10 months into use.

Product is great, appreciate the seller for having a hard to find plug

It's worked perfect

I still use an old Alesis Multimix 8 USB as a synth submixer, and its factory power cable's exterior wire had pulled back, showing the internal wires. Those were still wrapped, so I had carried on using it, but had it in the back of my mind to replace. When I saw this for review, at first, I didn't think that it would be a power supply for an old mixer from a different company than was listed in the heading, but the connector looked right, so I checked it out, and they namechecked my exact mixer in the main text, but right next to a note about differences in output voltages, assuring me it wasn't a problem. I was still a bit concerned, but gave it a try, and it worked with no issues, as they said. It is worth checking the specs against the adapter for your particular mixer, but I can confirm that it works well with the model I use, at least, and I am happy to have replaced an ailing power supply with one that is new and well put together.

This device failed within ten minutes. No power. The unit was extremely hot several minutes after it failed. These units usually emit a fair amount of heat, but this one ended up failing.

Needed a replacement power supply for my mixer. Make sure you get the right voltage and pin out. You should be good to go. Basic strain reliefs. Basic AC plug. No ground. Depending on your environment you may still have some hum. Dual power supply is handy for split circuits and keeping the buzz out of the prime circuits.