amFilmAuto-Alignment OneTouch for Samsung Galaxy S24 Ultra 6.8'' Screen Protector + Camera Lens Protector, Tempered Glass, 30 seconds Installation, Bubble Free, Case Friendly, Anti-Scratch [2+2 Pack]

Let me tell you how extremely happy I am with this screen protector. This protector (both screen and camera lens) was put to the test and proved its mettle. I recently fell on an escalator, while holding my phone. I am not small. Reach out my arms to stop my fall, with phone in hand, and proceed to drive the phone right onto the teeth at the edge of the escalator step in front of me. The phone saved my hand from injury and the amFilm screen protector saved my phone. The protector is not shatter proof, as that is impossible, and with sufficient force it will indeed shatter. However by taking the force of the hit my phone's screen was completely undamaged. Completely intact. I should have taken a picture of the damage but let me just say that it didn't just crack, or even just shatter, it was pulverized at the point of impact and spider web cracks spread from there. I was positive there must have been some sort of damage under the crushed glass, but the screen was perfectly intact. After dropping the phone on gravel the cameral lens chipped and cracked. Only by using a utility knife blade could I pry off the lens protector, which came off in one clean piece, no fragments. Which, now that I think if it, I should mention that when I removed the screen protector, even with all of its damage, it pealed off cleanly and in one piece, no fragments.Then came the day to install the spare protector leftover in my original two-pack. I cleaned my work area as dust was a problem for my last install. Then proceed to install both the amFilm on my personal phone and, while I was at it, install a company provided $45 ZAGG screen protector on the new company provided phone. I started with the ZAGG on the Pixel8. Simple instructions. Followed the instructions. Applied the glass, and spent 10 minutes smoothing out air pockets under the glass and ultimately it didn't fully bond to a sliver of the screen in one corner.Next came the amFilm. By just previously installing the ZAGG did I then fully appreciate how much easier, precise, cleaner, smarter the amFilm application process was. ZAGG has you place the phone into a bracket that contains small nub posts that are for alignment of the glass. You then have the handle the glass itself, position the glass on the posts while not touching the adhesive, not letting it touch the screen too early, and sweating the whole time while you attempt to get the proper alignment. Then you are smoothing out the bubbles from under the glass for the next 10 minutes. I don't apply screen protectors all day, as if I worked at a retail phone store, so I'm sure there is a better Pro technique than just simply following the included directions.Now, compare that install to the amFilm. Same cleaning and prep. But some things are just smarter, which translates to better. First, there was a dust removal "sticker" in both kits. The ZAGG had a small rectangle that 2 fingers can hold, and you need to tap that sticker all over the clean screen to remove dust that might have come from the cloth wipe or fall from your person. That's a lot of tapping and motion over the screen that might allow other dust to land while your are moving your hand around. In comparison, the amFilm has a single sticker so large it covers the entire screen. You apply this sticker in a rolling motion to avoid bubbles and leave it there until you are ready for the last step. When ready you peel off the dust sticker and hustle before any dust lands. Next you hold the plastic alignment bracket, that also holds the glass within it. You peel the film from the glass and gently maneuver the bracket until it fits over the phone in perfect alignment. The interesting part is that the glass doesn't yet touch the screen, until you press down with your finger. You then Slooooowly slide your finder along the bracket opening, from top center of phone to the bottom. You will see the glass make contact and a wave of solid bubble-free clarity crawls across the phone. Then you remove the bracket and in the same motion remove the top film from the glass. I was simply amazed that there were zero bubbles. No time needed to scrape away bubbles and hope the glass is bonded. Plus the bonding was complete, all the way to edges and corners. Unlike the ZAGG which had the one loose corners that didn't quite bond and I know dirt will collect in the gap over time.Bottom line: Amazingly strong protection, difficult to scratch the glass, removes cleanly, applies flawlessly and stress-free. Did I mention there are 2 protectors in a pack, includes camera lens protectors, and is reasonably priced??

Genius. I swear its absolutely genius, my brain is blown because of all the times I previously suffered trying to apply a stupid flimsy screen protector.I opened the box and at first was confused but just read the instructions, first. Read the full instructions that are inside the little package of accessories. That way you wont mess up.Ive never had such a neatly applied screen protector. Plus, the fingerprint thingy works even with the glass.If you run into an issue where dust somehow gets under the screen protector as you apply it, remove just that part carefully, and use one of the dust removal stickers. Dont remove the screen protector all the way.A little piece of dust got on at the end of the application so I just lifted the bottom up a little and used the sticker to get the dust, and then firmly pressed it down.Not a single bubble, dirt, or crookedness.

Great product, good price and basically impossible to install wrong. Use the included QR to see installation video. The only thing slightly tricky is removing the "mask film" in step 2. It is so precisely made it appears that it is not there but if you carefully use your finger nail on the top edge you will be able to find it to pull it off. In step 4 it says to move your finger SLOWLY. For best results, move your finger very slowly (if you look closely, you will see the protector adhesion spreading our side ways as you are moving your finger down. There are no instructions on how to install the lens cover. I recommend when using the included Wet Wipe and Microfiber Cleaning Cloth on the cell phone screen, do the lenes and the areas around them as well. If you have a magnifying glass, use it to confirm the lenes are clean. After installation, press firmly all around the lenses cover to confirm it is well installed because the sticky areas are small.

This is the best screen protector I've ever had and will never change product as long as they keep the same quality (hopefully) across all the samsung phones and all of the samsung future phones. In fact, this is the second time I bought this. First one was for my S24 Ultra, although there was 2 screen protector ( which is a big PLUS for the price!) I had to use both of them on my phone to test the fingerprint which will be added in the pros and cons section. When my wife bought an S24 Ultra, I had to buy another one. And here's why I only gave it 4 stars. So like I mention, it comes with 2 screen protectors, so I cleaned the screen of the phone first, took all the dust, made sure it's spotless, then I put the screen protector. When it was on and was cleaning it then I noticed there was two spots that was on the screen protector (see pic) I tried scrubbing it off but it won't go away and they were causing to bubble up inside. When I took it out, i tried scrubbing it again from the other side (the sticky side of screen protector) but it still won't go away. Sadly, i have to use the other one and this time it went well and no defects. Would've been nice though to have that extra one just in case specially that we're traveling outside the country.Pros:- Very very good screen protector- Really inexpensive product for what you get!- Oleophobic last very long ( I've had mine for almost a year now and it's still great)- You don't have to re-register your biometric if you use the same exact screen protector or same product. I have tested it and it works like a charm- Great quality 👌- Case friendly ( I have a UAG which pretty bulky)- Super easy to installCons:- tbh, I couldn't think of any cons except for that one defect we've experienced