🔧 Stick with the Best: Your Go-To Adhesive for Every Project!
The MG Chemicals 8349TFM Thermally Conductive Epoxy Adhesive is a two-part adhesive that offers exceptional thermal conductivity, flame retardant properties, and strong electrical insulation. With a convenient 1:1 mix ratio and quick curing options, this adhesive is perfect for both professional and DIY applications.
D**N
Good epoxy!
This epoxy worked well for our applications. Not sure why the negative reviews.
A**R
Requires special attention
Keep in fridge or it will not last all that long
S**I
Worthless!
One of the parts was solid and unusable. Will never buy this again.
J**F
Nice to have
It works well, and it’s nice to have. Just like glue. Definitely conducts the heat
J**S
Part B stays in the syringe
When first opened, Part B would not come out, while Part A was squirting. First tried only pushing on the Side B part of the plunger. Finally had to insert a toothpick into Part B and stir it some, then a little would come out. I only needed a small amount, so when I can get a little of Part B out (some just from the toothpick), I take an equal amount of Part A from the Part A puddle. If I needed a larger volume of epoxy, it would have been unsuccessful. The epoxy does cure into a tough solid, and it seems to be adhering to both metal wire and the plastic wire sheathing.
J**H
It sticks, compared to the many others I have tried. Make sure you mix the compound!
Mostly likes, It is kind of hard to squeeze the product out. If you can't get the conductive compound out Take a small instrament and open the pathway to get it started. It works. Don't give up!
C**S
Hardener partially cured on receipt
The product arrived as scheduled but when dispensed, the resin flowed nice. However the hardener didn't flow at all. After dispensing it by cutting through the body of the tube, it DID perform well.
N**L
Best used in very thin layer
Thermal conductivity about 3x what JB Weld is, not as good as thermal grease, but it adheres and grease will not. Spread it VERY thin, and clamp. Shipped fast, dispenser is of high quality.
I**Y
very strong bond, but..
However the two syringes dispense unevenly due to vastly different viscosities. I managed to somehow get two equal lengths, but this double tube thing is an incredibly stupid idea. Several manufacturers also use the bad design. I'm going to try to cut between the two to separate the plungers. But the thermal adhesive is very good otherwise. Used it to mechanically mount COB LEDs to a heat sink.
L**Y
Works
Works as advertised.
K**K
Works well, suggest heating.
The product works well, I purchased it to adhere thermistors. I strongly suggest finding a way to heat the epoxy to increase the curing time, I used an old toaster oven that I no longer use for food and it curved in 15 minutes. One word of caution, one part of the epoxy is more viscous resulting in uneven extrusion from the plunger. Be sure to take your time to allow all of the epoxy to be pushed out.
Trustpilot
2 months ago
1 month ago
