JENOLITE Rust Converter Aerosol, Rust Neutralizes for Metal 3x16.9oz

Works as advertised.

Used this to coat my sub frame before replacement. It did a really good job!

Works like it should

I wish I had taken a before and after picture. I was concerned about the rust on the trailer of my camper. Very easy to apply. Dries quickly even though I gave to 48 hours to cure. It doesn't get rid of rust, but it does from what it looks like bonds it. The rust wasn't over excessive for the most part and I did sand down a few areas so the product would work. Obviously it's not a smooth surface but I was looking for a solution that I didn't have to grind and sand. I did cover over it with a rust protector. I'm really happy with how it turned out. Time will tell.

Follow the directions carefully. Spray OUTSIDE. Prepare to leave whatever you're spraying OUTSIDE for a minimum of 2 days with any sprayed areas OPEN. The fumes will go away, but they are very strong. The warnings on the can make this very clear. I used it to spray rust in the spare tire well in the trunk of my car which didn't rust due to water intrusion ... nooooo - it was mice that made their home in there. Their 'biological leavings' ate through the paint and caused rust. Also applied to other various areas that made light surface rust after sanding in the process of repainting a car. Coats really nicely, had no problem putting an epoxy primer over the top of this stuff (I gave it a week). Worked exactly as advertised. The more work you put into preparing the surface, the better the product will work.

Did what it was supposed to do well.

Sticky mess. Ok if you wait a week for it to dry

Quality product

application facile

Absolutes Top Produkt. Konserviert die Stellen gleichzeitig und ist überstreichbar

Très bon produit.on voit l'effet directement après pulvérisation..la rouille doit être bien nettoyer avant bien sûr.. laisse un film protecteur genre vernis qui peut être repeint dessus sans problème.ou laisser comme ça.. ça donne l'effet noirci.

Applied to a 64 plate focus st tdci with 89k on the clock. In the last 5 years the car has received a couple coats of lanoguard so car wasn't too bad underneath to begin with, but subframes and few suspension linkages were looking a bit tatty so this time around i thought I'd try something different! I used a drill to wire wheel the worst bits off where engine tray has encouraged rust over time with the view of applying this then painting with hammerite after drying period. HOWEVER, i was more than happy with the reaction and how it looked once applied and left to dry. As a result i decided not to bother coating with paint and potentially making the rust worse in the long run. With MOT due in the next month I also decided I would rather it look genuine and tidy than looking like it had been painted to hide issues Again whilst at it i coated a lot of other areas as a bit of a future guard. It dries to a good sheen whilst leaving a protective coat so happy with result. I put a liberal/ 2 coats on most areas so in the end i used 2 tins exactly. Being an aerosol i also found it easier to apply than lanoguard and wasted less product as it was more controlled application. Hope this helps future buyers!

High quality rust converter spray. Nedded fir car body repairs and where you need to fight with rust. Clean the place of rust, spray it and wait to dry about 20 min. and paint. The job is done very simple.