Black case

Installed these on the bottom of rear hatch of my suv. Wired them so they go on with the rear cargo area lights. When hatch is opened at night, they provide a bright led light for oncoming traffic to see. They are even very bright and visible during the daylight. Work well, easy to install and wire up if you have basic 12v wiring skills.

Very bright ... well constructed.... I have purchased three different colors...

Super bright but wires are thin I used them to rebuild my Drl lights

I used one of the bulbs to change out a landscape Bollard LED fixture. Option1 buy a new 30 fixture, Option2 cut out the old bulb and wire in this new one. The wire is very thin but manageable. Bright white new bulb on the left. Unless I am mistaken there is a typo, these bulbs have polarity. Also after doing a few of these the wire is VERY thin, which does make it very difficult to use. Be aware

Great product

They fail after little use

Like the amount of light they produce and the flush mount , however the quality of the wire is lacking and very small strand and seems to break easy. Had to use 6 to find 4 that work consistently. Also the sealant ?? That was used is poor and needs more if in the weather . Not sure if I’d buy again . If you need all 10 to work buy 20? Great idea but quality of the ones I got are hit and miss , already installed so not likey I can return them

I had been looking for lights like these. A bit hard to find. These are easy to install, Small and yet quite bright . I am very pleased also a great price!

Durano pochissimo

Great little flush mount led lights. Very bright and seems well made. Great for my bullbar as Im using them as daytime running lights. Positive an negative wires are very small gauge but then again the lights dont draw too much power as it looks like they only have 2 leds per light. I would buy again.

I'm ordered this product about five times and friends have too,great product and very bright

These mini LED focused beam lights are very bright. RED is warm to the touch 99F and I will be using them in some tail lights and with two or three ganged together, they could be bright enough for brake light level. YELLOW is hot 151F to the touch and will be fine for turn-signal use. WHITE is hot 156F to touch! Will be good momentary lights like cornering or full time DRL. I'm putting them in a metal housing to act as heat sink. I've plugged them all into a 12.7 volt battery for overnight to see how they do. I got the 10 unit pkg of each. Very reasonably priced. Aluminum body structure which you need for heat-sink capability. Wires are very fine @ 24 AWG and you'll need a soldering iron to attach them to any connector. I measured the heat with a Cen-Tech infrared thermometer +/- 1 degree I mounted them in an aluminum panel and the temps did come down 7 degrees with the white and yellow, but they still too hot to touch and might not be suitable for continuous use in a plastic housing unless there's lots of airflow.

Feu de jour pour ducato ou autre anti erreur Montage super facile Eclairage très fort