Slime 20076 Tractor Core Housing Valves - TR218A / TR618A

Well built, feels sturdy and I like the metal body. Holds cores inside of it which is convenient and brings more functionality to the tool. Helps to protect what your working on so you don't over tighten and smash o-rings.

I used the tool to remove a valve from a self- sealing tube, which had begun to leak. I was able to remove the valve and clean it and eliminate the leak. My only complaint is that the tool length is just slightly too long and this caused the removal and replacement to take just a bit longer. All in all, this is a nice, compact, helpful tool to keep in your repair kit! (Ironically, this tool is made by the same company that caused the leaking valve)

Got this to remove stem from tire that was not taking air properly and was flat with no seal at the rim. It does what it's supposed to. It is also good to have extra valves around in case you get one that leaks at the stem. It was very reasonably priced and shipped fast.

It worked as I expected on my fat tire bike. It might be too wide for my wife's road tire bike. The spokes are too close for the wrench to be used easily.

Had a little leak in a valve stem and this fixed it right up. Simple and useful tool, good build quality.

I love having this tool to remove and install the valve stems in and out on the valves and occasionally just check to see if they(the valve) are tight when a tire is loosing air. its a gotta have tool if you have to fix a flat anyway and inexpensive to have on hand. the extra valves will not go to waste if you don't lose them

Worked like a champ replacing the valve stems on my John Deere LP21935 cart. I rated it 5 stars on "easy to install" because of the fact that it's not the value stem that makes the process a little difficult. It's the fact that it just takes grunt work and getting your hands dirty to get it done. Here's the basic steps I followed:1) Remove the wheel (hammer and flat-head screw driver to tap out the retention clip),2) Deflate tire,3) Use a 4lb hammer to "break the seal" (this involved smacking the tire until the bead broke away WITHOUT hitting the rim),4) Used a pry bar to separate the tire from the rim and position my hand behind the inner-valve stem,5) Use a Vise Grip to rip the old value stem out and catch the inner part and dispose (if it dropped inside I don't think it would matter since this is a low speed use),6) Carefully position the new valve stem into the hole from the inside (don't drop it like I did or you'll spend 10 minutes shaking the tire around until it falls out to try again),7) Use pliers to pull the new value stem through the hole until it pops into place. (Don't jerk it super hard or you might pull it all the way through),8) Reinflate. I didn't have to clean the bead or anything like that. It just sealed and is holding great,9) Slide the tire back onto the axle, ensuring you install the first washer, then the tire, the second washer and then the retention clip.,10) Position the retention clip into the groove with your fingers and then use the edge of a flat-head screwdriver and a hammer to gently tap the clip back into place.No fancy specialized tools were required for this job.It was so easy, I went ahead and replaced the value stem on both tires even though only one was bad.Hope that helps!

Used for my Lawnmower and are durable and fit just right.

These are 5/8 diameter stems. A little rare to find at a normal shopWorked perfectly for my application

As described

Fácil e prático de utilizar e os núcleos das válvulas cumprem o pretendido, meu problema com o pneu da minha moto foi solucionado.

Bon bidule

..