Hakko T18-BR02 Soldering Iron Tip Angled R0.2mm/30° x 10.5mm, Silver

I hooked on this tip

Expensive but good. There are many cheap imitations but none sadly live up to the performance of true Hakko soldering bits. These are especially useful for small SMD resistors and Leds. SMD Chips are good with these tips as you can fix each end point down and if you have overdone the amount of solder you can rotate your iron 180 degrees and drag across the terminals and it will even out the solder. I do like them.

Good for the price so far. Does the job good

I needed a new tip as my old one didn't hold any heat and was a nightmare to use. The soldering iron I use is a WORX WX744.9 and this tip first perfectly. This has really improved my soldering game as it holds heat really well and can melt solder even using just the very tip which my old one couldn't so this is a great buy I'm very happy with it

Good little attachment, fits the soldering iron perfectly.

This tip. This tip is the best tip I've ever used. It's a very multipurposed tip making it a great selection for lots of surface-mount work and some through-hole stuff. It's phenomenal for drag soldering and it doesn't fall short when dealing with large anchor pads because you can just angle it so the fatter, wider side of the tip is against the pad for better heat transfer. The smaller conical end of the tip can be used for individual soldering of pins as well, albeit not as finely as an actual microsoldering pencil. If you want to do any kind of SMD rework, this tip is a must. It will make your life a lot easier, and in my opinion it is better than the conical tips because you can angle this in many different ways for better heat transfer based on what you're trying to do. With conical tips that is much harder to do.

It's the real thing. I can't comment on all the clones out there, but the Hakko tips are really good.

Muy buena punta, ya que es delgada pero a su vez eficiente en la distribución de calor.

Excellent choice for microsoldering hobbyists. As normal for fine solder iron tips, consider lowering the temperature to avoid early rusting. Yes, I would buy it again.

シートの穴あけ用に購入しました。先曲がりなので持った時に楽に作業できてます！