3M VHB Double Sided Sticky Pads – Heavy Duty Dash Cam Mount & Action Camera Adhesive Pads, Heat Resistant, Compatible with Nextbase & GoPro, Includes Prep Wipes, 44 x 34mm (Pack of 6)

I used these 3M adhesive pads to mount a small smart home sensor and secure several lightweight cable clips. I cleaned each surface first, allowed it to dry, then pressed the pads firmly into place for around thirty seconds.The difference compared with cheap unbranded pads was obvious. These grip firmly without feeling thick or spongy, so mounted items sit close to the wall instead of sticking out. The sensor has stayed in place despite being handled several times, and the cable clips have not started lifting at the corners.I found them easy to trim with sharp scissors for smaller accessories. Removal takes patience because the adhesive is genuinely strong, so I would not use them for anything I planned to reposition regularly. I also avoid using them on delicate wallpaper or weak paint, as the bond may be stronger than the surface underneath.For permanent or semi permanent mounting on smooth, clean surfaces, these have been dependable and worth paying a little extra for.

I was a bit worried after watching video reviews that suggested they were rubbish but I found no issues. They were very sticky and I managed to mount my dashcam without any problems.

Much superior to the ones provided when my windscreen was replaced. They only lasted 2 weeks before working their way loose. Used to secure my BMW Advanced Eye 3.0 front dash cam to the windscreen. Has held up well in the few weeks it's been on, even with the record temperatures we've been experiencing in the UK this summer!

Very sticky. Easily cut down to size with scissors

Absolutely brilliant and very strong, holds me dash cam up front and back and also my wing mirrors the stick on ones, cannot fault them!

They’re ok - very difficult to get the red side off the sticky pad. Not sure how long they’ll grip for but so far been stuck on 48hrsUsing for phone mount which came off in the heat.

Whilst quoted for my model of Satnav, it had to be trimmed down to size. Not a big issue and it did do a very good job

Done the job

Musste meinen GPS Logger an die neue Frontscheibe kleben.Keine Probleme.Nur beim abmontieren des Loggers ging dieser Kaputt. Weil es zu gut klebte... :-))Wenn du mit dem Auto einen Überschlag hast oder von einer Brücke fällst, Klebt das immer noch.Da gab es doch bei Pippi Langstrumpf auch so was...……………………...