Type B F4T5/D LED Tube Light, 6-Inch, Daylight 6000K, 110/120V AC

This is really an amazing product. My under-cabinet lighting was the old GE 8 inch fixture GE Slimline Fluorescent Under Cabinet Light Fixture, 8-Inch 10167 . The lumen rating on the fluorescent bulbs is 130, but they dim pretty quickly and look pretty dull. These bad boys are rated at 200 and they have a beautiful white work light color. Unfortunately they are not plug and play, you have to remove the ballast from the old fixture and in this case, they were manufactured to fit tightly and they will take a bit of effort to retrofit. The fixture is a sealed plastic unit and you have to cut it open to get to the ballast. I purchased one of these WEN 2305 Rotary Tool Kit with Flex Shaft and it had everything I needed to carefully perform surgery on the fixture. I sent several emails to the Fulight people and they were extremely responsive and helpful. It is a tight space, but if I can do it then anyone can. I estimate about 4 hours in total on the project, but most of that time was figuring out the best way to remove the ballast and rewire the fixture. I did 5 in total, the last four took about an hour to complete.

Works great. Brought my Schmidt's beer clock into modern, efficient, LED lighting. Easy replacement for my flourescent tube. LED is direct so you have to bypass the ballast, this required a little rewiring trickery, but got the job done. This comes with instructions on how to bypass the ballast I cannot say if these are good or not, as I did not use or need them.

As it was described

These lamps are a simple drop-in replacement for the original fluorescent tubes that were in my RVs overhead lights. They work perfectly and cast a much brighter light that is comfortable and clear. They don't get hot like the fluorescent tubes did, and consume much less power so when I am boondocking, I'm not using as much battery and therefore I am able to have power for longer periods between utilizing the generator.

installed this bulb in an old bar light that ran a fluorescent. Removed the ballast and momentary switch, which left only the bulb ends to be connected. Used wire nuts and was done in 5 minutes. Nice and bright-easy to do with included instructions.

A direct replacement LED lamp. Perfect for a 1980s Bally E series slot machine, or any other project where you need a 6" LED replacement for a 6" fluorescent tube. Remove the ballast and starter, wire one set of prongs to Hot 120V, the other set of prongs to Neutral. Rotates as well just in case you need to adjust brightness to you taste.

Replaced a fluorescent bulb in my beer sign. Instructions were right on and helpful. I like that the instructions were included for do it yourselfer’s.