URBEST 5Pcs Terminal Block 4 Position Dual Row Screw Covered Strip 600V 25A with 400V 25A 4 Position Pre Insulated Terminal Barrier Strip Red/Black 10Pcs

These are solid terminal blocks, and the cover is nice. The plastic of the terminal block doesn't appear appropriate for heavy duty use, but neither is it fragile. Don't over-tighten when mounting the blocks. While I haven't had one break, the cases clearly could. I'd say they're appropriate for light and medium duty use. I'd recommend them as a good value.

Good quality, Solid build, Happy with the purchase.

I needed to clean up the wiring of an ever increasing number of LEDs and other low power devices on my bike. Since LEDs have very little current draw and the other items already had inline fuses, a fuse box was overkill.These barrier strips are just the ticket. Simple with a capital 'S'. Easy to sort, with multiple possible wiring configurations, and very compact. The clear plastic top keeps other bits from straying onto the connections.The jumpers allow you connect one power source to four terminals and for devices. You could connect up to eight devices if you used two per terminal. The jumpers can be cut to connect two to four terminals and multiple power sources to feed them. For instance, cutting the jumper in half would let you connect a battery lead (fused) to two of the terminals, and a lead from the ignition for switching devices on and off with the key.I used two at the back of the bike (left and right), under the seat with one ground (Negative) and power (Positive) from from the brake lights, tail lights, and turn signals, on the top row. The bottom row is for the connection of the various LED marker lights.No mounting hardware is included. There are two holes for machine, sheet metal, or self-tapping screws. Small zip-ties could be used in the holes, but then the plastic lid couldn't be attached. The lid doesn't fit very tightly and vibration could possibly shake it off if mounted at an angle. Mounted flat with the lid up, it might stay in place, but I used Teflon tape around the two pins to secure it.The insulated portion of crimp-on connectors can limit the number of connections to a terminal. In general, I prefer using uninsulated connectors and adding heat shrink tubing. This takes up less room.A simple, inexpensive solution with a fair amount of utility. I like it.

I like the design and the transparent covers. Easy tap off with the included connecters. Will make a very organized installation.

Got this item overnight by Amazon Prime. Terminal blocks are exactly as described and one has been installed already. These are a very good value for the money!

The terminal blocks and jumpers work well together. The terminals work well with both solid and stranded wire. You can even put two of the same size wires under one terminal - one each side of the screw. There are enough of each color jumper to enable you to use all the same color jumpers on each terminal block. On my next order, I will just order the terminal blocks, as I have enough jumpers for them.

Good connection. Will buy again

Bought to organize low voltage (24v) wiring for my front gate. Needed 3 as I have positive, dusk-dawn positive and negative. The bridge plate is brilliant as it gives you multiple terminals for each connection. The conductor screws are strong and can be tightened hard but be careful mounting the block as the mounting holes can’t take much tightening - hand tighten only, don’t use electric driver or drill.