Franklin Brass D2405SN Futura, Bath Hardware Accessory, Toothbrush and Tumbler Holder, Satin Nickel

I searched for one of these in satin nickel finish for my bathroom for months. I couldn't find them at Lowe's, Home Depot or anywhere to match everything else in the bathroom. Fortunately, I decided to check here and found them. It's durable, hasn't rusted and hope it doesn't. Keep in mind this holder does have larger holes for your toothbrushes that might make it fall through the holes. If that's the case, find another toothbrush holder or some larger handled toothbrushes.

Solid construction with large holes for the brushes. I have yet to find a toothbrush that fits. My usual is too large others are too small. I don't mind as the holder I had before had too small holes for any brush. I just lean my brush against the side of my medicine cabinet with the lower 1/8 of the toothbrush in the hole. The finish is flawless. The holder goes well with my kingsley accessories without a lot of expense.

Very well crafted and the finish is great. The holes are too big for my toothbrushes so I made Fimo inserts i can slide on and off for cleaning.

I was pleasantly surprised to see the finish is a true satin/brushed nickel. It doesn't come with a tumbler but I guess that should be easy enough to get. The holder comes with mounting plate, screws, and anchors included- all which remain concealed after mounting.Unfortunately, I will be returning this holder. The problem for me is that the oval toothbrush openings are too large to hold standard toothbrushes. I use an Oral-B Indicator Toothbrush and it falls right through. The measurement of each opening is 1.5cm width & 2.5cm length. I know there are larger/bulkier toothbrushes out there, none of which I use or like. Too bad, because it's a nice-looking holder...it just doesn't work for me and may not for you either if you use a standard-sized toothbrush.If you are looking for a holder with small openings for thin/flat handled toothbrushes with little to no silhouette, then I recommend the  Taymor 04-SN4905 Diamondback Series Toothbrush and Tumbler Holder, Satin Nickel .

The small rectangle holes IN THE PRODUCT PICTURE FROM AMAZON are not on this product. Instead, there are HUGE OVAL HOLES that even the largest toothbrush falls right through like a cartoon character stepping over a cliff.Got my return shipping label and I'm sending it back tomorrow. DO. NOT. BUY. THIS.Edit: I can't stress enough how useless this product is. I have one of the biggest toothbrushes dental marketing hath invented and it slips right through. I can't imagine any way to make this product work, short of welding in some new metal to make the holes smaller.

i couldn't believe this was so inexpensive and so high quality, it is great, the finish on it is beautiful.

As there are not many wall mounted toothbrush holders available, I was happy to find this one. It was nice looking but unfortunately the holes for the toothbrushes were too wide and the toothbrushes slipped through. The hole for the cup was too narrow and didn't hold a standard size bathroom cup securely.

works very well for where we needed it, If your toothbrush doesn't fit inserting from top to bottom, we have found putting it in from under the holes starting with the bristles, fits all our toothbrushes. would recommend it.

Nice looking. Easy to install. Doesn't fit our toothbrushes. The kids sure but not ours... But we have a cup inside the circle and at least it keeps everything off our sink to save room/ doesn't look so cluttered.

good product.would have given 5 stars but the toothbrush hles area little small.had to sand handles down to fit