Condor LCS Cobra Gun Belt

Used this belt as an Infantry squad leader. My first concern buying this belt was that condor makes cheap gear and cheap gear doesn't survive the field when your a grunt. So I bought the belt right before my unit did an XCTC rotation in Yakima, Wa. hoping I could return it if it broke, but the belt did great. Not only did it survive intact, but it exceeded my expectations. It survived about 3 weeks in a high altitude desert covered in harsh brush and lava rocks. Works fine in sand and heat up to the mid 90s. Judging by how it held up I think it would do well in wet and cold, but I can't be sure yet. I didn't need to modify the belt by reinforcing weak spots or adding suspenders. It just works as is. It also supported a good amount of weight as you can see in the pictures, which were taken after I used it in Yakima. The belt has from left to right. Carabiner for gloves, grenade pouch (for Harris battery), dump pouch, Gerber, 1 quart canteen with cup, IFAK, 100 Rd SAW pouch (used for NVG's), General purpose pouch (for peltors, eyepro, or smoke grenades), 2 more grenade pouches(for headlamp, signal marker, and compass). I have a 34" waist and the small fit me over my uniform and belt at the largest setting. The rubber pad stays in place well the only time I noticed the belt sliding up and down was about 2 weeks into training when I had to tighten it up because I had lost some weight. I may try using it with a velcro inner-belt in the future. If your a grunt you need this piece of gear, this saves space on your chest for ammo and redistributes weight to save your back.

I purchased this belt for work after using a more expensive version from another company that also sells their own line of affordable body armor. From my initial assessment, the molle webbing seems just as sturdy and durable, albeit perhaps a little less sleek looking in its design. I love that the belt can be adjusted from both sides of the cobra buckle, and that the manufacturer included velcro on both ends of the outer belt to keep it from loosening up. I also like the design used where the excess belt loops BEHIND the webbing, rather than overtop of it like other more expensive designs.I recommend to anyone looking at ordering one of these belts to size up rather than size down (I purchased the medium/large - my waist size is 32), so that you can have the molle webbing as close to the buckle as possible and thus be able to put whatever pouches you need up front as close to center line as possible. With my old belt I had to macgyver a system to mount my mag pouch to the excess non-webbed portion to prevent it from flopping forward as the excess belt is not as rigid.I’ll try out the padded insert that comes with the Condor belt, but I prefer wearing a loop inner pants belt with suspenders and I anticipate that I will ultimately end up going that route. Nice to have that option included if that is your preference. The cobra buckle seems sturdy - I’m never going back to those cheap plastic clips on the traditional nylon duty belts unless I’m required to do so!

Wanted an affordable kit setup for recce hikes in the PNW so I started checking out condor. So far have tried chest rig, belt, 3l water bladder, pack and various other pouches. Not been disappointed at all.Belt: ordered what my waste size was and it ran big, accepted return quickly and ordered next size down. Fits perfect. Molle, has inner velcro belt, live the quick detach buckle.Stitching well done. Between IFAK, drop holster and retention system, magazine pouches, drop pouch and tourniquet while hiking rough terrain in wet weather is still holding strong.

I’ve worn different variants of belt setups. This one is specifically designed for an exterior mount.It provides the adaptability to install systems through Molle or a variation of it. I tried installing to generic Blackhawk mag holsters that are non-molle to avail. The exterior belt system is too large.As for the comfort and support, it was better than what I expected. The interior padding has a grip like material which prevents a lot of sliding. Durability will be tested for sure, because it does not feel entirely made of quality. To put it simply, it feels cheap, but worked very well. The cobra buckle system is nice and solid. Smooth to operate. The laser molle is a nice touch. Prevent anything from being hung up on it. This is my first Condor and my first laser etched molle. Hopefully the past reviewers were right on how good it is.

Bought for a 44 inch waste ( Large/X-Large: 46.5” - 50.5" Long, Waist 38”-40” LCS Cobra Tactical Belt 121175 ) fits perfectly. Purchased in Aug 2021 and wear daily.Solid construction has a gel filled inner liner that really improves the wear time and comfort. ( Gel insert can be easily removed so you can run the belt normally ). This is a real improvement to the other tactical bets that I own. If you carry for law enforcement or open carry this is the belt for you. Its built like a tank ( American ) Also a great outdoor tool belt.For the price point ($75.00) you can't beat it. Will be buying another.

Holds up well, stiff material I wanted for the purpose in mind. Holds my girlfriend MOLLE personal items very well, from stream light to Smith and Wesson everything fits right in its place. Yes it’s expensive but I’ve learned you get what you pay for and these are worth the price. Wraps around my favorite bag very well and I hope it remains suitable for many purposes in the future.Again a great product and well worth the price one of those items you’ll only have to buy once from what I can see.