AFUNTA 12 PCS 12V 40W 620 Ceramic Cartridge Heater and NTC Thermistor 100K 3950 Fit 3D Printer & Heat High Temperature Resistant Adhesive Polyimide Tape for Electric Task - Red & White

I bought this mainly because this is a set of 6 of each of the wires.I thought to myself, "It does not matter if this is a poor wire, I will get my printer going again"I received the wires, the Heater is of better quality than my TronXY P802 original heater, and the thermostat works flawlessly.This is perfect replacement for either in your 3d printer.

I have three 3D printers and bought them for spares and repair. Both the thermistors and ceramic heat tube are good quality.

Great and just what I needed for my 3d printer

perfect thanks

I can't speak to the quality of the thermistor or heater cartridge as of yet, because the wires are of such terrible quality that installing them has proven impossible thus far.While the outside diametre of the wire sheathe is superficially similar to the original parts that come with an Ender 3 Pro, the *actual wire inside* is noticeably thinner in the case of both parts. The white wires that come on the thermistor are so bad, I haven't even been able to insert them into a JST XH housing after crimping the ends, the wires just bend and cut themselves on the metal connector regardless of how much they're coaxed and carefully prodded.Absolute joke, and I thoroughly regret actually trying to make them work rather than just returning them as unfit for purpose.

I originally reviewed this after I fitted and heated it up, however after 2 prints... the heater element stopped working!! Not bothering fitting another one. Just re-ordered a genuine hot end!!