CRLTranslucent Vinyl Bulb Seal for 10mm Glass by CR Laurence

I have to say I was impressed with the packaging it was shipped in. That's it. This is suppose to be for a 3/8" opening.... As you can see from the measurements I took right after removing it from the package, it's 7/16". And that opening inside is 1/2"-9/16". It literally falls off. It looks well built, but it's just not the right size. I put the measurements from my shower door on here to show the difference. Save yourself some money and pass on this.

Product seems like it is made of quality plastic but was unable to use it as it did not fit snuggly on my glass door, despite having measured for proper door width. As such, it would fall off the door when opening/shutting it. Had to return and, unfortunately, the seller forces you to pay for return postage. Might work if you have a wider than specified glass door but I wouldn't risk it.

I was looking for something to fill a gap on a frameless shower door setup on the hinged side. I liked the bulb idea as it conforms to the door as it comes into being closed. The only one I initially found was one you had to glue on. No way. Then I found this type that slides on and it has worked great.

Works great, no more leaks. It seals the gap on my shower door (between the hinge side of the shower door and wall that it is anchored to). I have a rainfall shower head, which is in line with the door hinge. Only downside was the rubbing sound that it makes when I close the shower door, which is not a big deal for me. I had to cut it with a chop saw since the plastic area that holds onto the door was very rigid. I didn't want to try it with a knife/box cutter.Update: To stop the rubbing sound the seal made when I opened and closed the door, I cut off 1/3 of the bulb. The 2/3 remaining was on the side that was inside of the shower. I used a sharp pair of scissors and ran it down the 1/3 I wanted to remove, like I would when cutting wrapping paper off the roll, so it made a smooth cut. Then I cut the rest off using the same method on the outer edge of the bulb. The cuts were smooth so there were no sharp edges. The remaining 2/3 of the bulb is enough to make a seal to stop the water from getting out f the shower and my door doesn't make any rubbing sounds any more.

was not the fit I hoped for....the bulb is too big and causes the door not to close all the way. It does block the water well.

This fit perfectly on the hinge side of my door and keeps the water in the shower!

Nice quality product, but it didn't fit my 3/8 inch thick glass very well. I couldn't use it on my shower door hinge side, the gap was not large enough. But it looks like it could work on the right door. Would recommend this product, just be careful when you measure your gap.

Affordable and does the job for my shower. Shipping was prompt and economical.