3.3ft Floor & Carpet Threshold Transition Strip, Vinyl Self Adhesive Overlap Edge Reducer,Edging Trim for Doorway Flooring Laminate and Tiles,Beveled Edge Ramp Edge Guard,for 2/5" Thick Material

This trim transition was exactly what I needed! The quality is great, and it was super easy to custom cut with a razor for a precise fit. It sits perfectly in place and gives a clean, seamless look. So satisfying to install, highly recommend!

The tile from my bathroom to the vinyl of my living room has a sizable height difference, and this was the easiest solution and it looks great! The color of the fake wood on the strip is darker and more red than the paler, yellower vinyl wood flooring, but I don't mind at all.

Product was very easy to cut using my utility knife and easy to install. Been a few weeks and holding strong. Definitely recommend for a nice look and DIY project.

I had a small closet floor DIY project that required a transition strip to prevent a gap between the laminate and tile. This strip was the closest color match. It is a soft almost silicone feeling material that’s very flexible and came rolled. Since it was rolled, getting it to lay flat was a challenge.The tape was very sticky but due to the unevenness of the floor it was difficult to get it where it needed to go. I ended up using another piece of laminate to even it out and using gorilla glue and painters tape in order to get it to stay down.I had a considerable gap of about 1.5 inches between the floor types which is too wide but that’s just how the laminate ended up lining up. If this were the typical 5/8’ gap required between floor types then you should be ok and not have to use glue. You will, however, still need to tape it down since it comes rolled and you’ll need it to lie flat. I used painters tape so it wouldn’t leave a sticky residue and left it there 48 hrs before removing the tape. The transition strip looks perfect now and I haven’t had any issues with it rolling back up. I’d recommend this product for small projects like this or interior transitions.

Easy to cut and sticks well where there is adhesive. I wish there was adhesive on both the upper and lower portion on the bottom since the adhesive is only on the lower part that angles downwards but it worked better after adding some additional glue

I got this hoping to replace the “T” transition that broke off of my floor transition. I had hoped that it would cover the broken piece. It does not cover it. Also, my wood is freshly waxed, and the adhesive does not stick well to it. Both of these issues I am having cannot be blamed on the manufacturer; therefore, I am basing my review on the appearance of the strip and ease of use. The rubber is easy to cut with household shears and has a lovely wood grain. The grey has some variation of different gray and will therefore match many gray tone floors. The backing is removed easily, and installation is a snap. There are no instructions and no “floor prep” wipes. I suggest finding something to remove any coating or dirt from the floor before you try to stick to the floor. I will purchase it again when I have better prepped my floor.I did not take any pictures, but the listing pictures are a very good representation of the item itself!

Sticky as heack but secured like any floor trim to make sure it stays down by tacking it in with a nail gun but is a floor separator for my livingroom to woodburing floor to hallway. So you can see the different flooring an walkway easier. Easy to install very thick good quality fits perfectly an blends well.

This threshold transition was perfect to transition from the grey LVP flooring in our kitchen to our laundry room. It was just the right height to go from the LVP to the cement. The material is thick and durable and the sticky strip on the bottom is very, very sticky. It was easy to cut down to the exact length we needed and was simple to install.