XHF100 PCS 1.1" Black Self Adhesive Cable Zip Tie Mounts Wire Cable Clips Holders Management Anchors Organizer Holders Squares(HS-102)

Works as described and good 3m quality

Very well made, great stick and durable.

I bought these as a way to attach keeper cords to my plastic fly boxes (fly fishing boxes). Well, they worked perfectly for that. It turns out they are great for their intended use as well. I teach a class in a computer lab, and cable management is problematic. A pack of zip ties and these little guys make things better. Worth it!

I'm very new to these, but they can make a lot of caft projects so much easier. I hope I can find ones that have a bit more hold fast, some of these wouldn't stick.

They stick & do the job well

Wanted to attach my AirTags to earbud case but all the silicone cases right expensive or didn’t fit properly. Enter this. I stuck one of these to the back of case, made a small letting via a small zip tie, and added my AirTag. Works perfectly. If I want to remove it, dental plus and rubbing alcohol. Works way better than the cases I would have to buy at a fraction of the cost.

I had a chance to use these for an extension cord going up a wall with rough, decorative boards and they hold well. It helped clean up the TV wall where I don’t have a power outlet up high.

I don't like the pegs they ship with PCB kits now. I use these nylon tie mounts because it makes it easier to remove and re-base PCBs if you decide to install them into a different electronic housing. The pegs "punch" through the holes of the PCB substrate plastic and I'm worried the pegs will crack the substrate and possibly damage the PCB electrical trace, too.I use the tie mounts for arcade controller (joystick) PCBs. You only need to install two of these two zip tie mounts diagonally from each other to stabilize a PCB in an enclosure (joystick base).I've done things this way for over 12 years now.IF the adhesive fails OR comes loose, you glue the tie mount onto the enclosure with hot glue. I'd give it at least 15 minutes for the glue to harden BEFORE you reinstall the PCB with nylons ties. Oh, and be careful NOT to seal in the holes that the nylon ties slip through. That's the only problem I've had with reusing the tie mounts. You shouldn't run into reusing tie mounts with packs of 100 of these bases unless you're doing a ton of projects...

Funciona muy bien, hasta ahora el adhesivo no nos ha dado problemas, pero veamos cómo se comporta con el tiempo.

I have been using this to hold ethernet cable to a metal chassis. Product works well.

Finalement reçu la bonne chose

Cuando los vi supe que los necesitaba. Gran complemento para los cintillos, uso múltiple y un gran agarre del pegamento. Magnificas ¡!

Me vende 500 y envía 100. No me gustó esto del no proveedor. El producto no es malo. Aclaro esto para que no se dejen guiar por lo de mala calidad.