iPhone 6s Screen Protector, Spigen iPhone 6 6s Glass Screen Protector [3D Touch Compatible- Tempered Glass] Most Durable[Easy-Install Wings] Rounded Edge [Life Warranty] - Glas.tR SLIM (SGP11588)

Great screen protector! Does not provide an edge-to-edge protection in terms of the full front screen but that's understandable due to the curved edge design of the 6s. However, what Spigen did well was provide a product that sealed well around the edges of the cover! If applied correctly, the screen protector spans from one edge of the visible screen (excluding the curved bezel) to the other edge (width-wize) and from the bottom edge of the home button to the top by the proximity sensor. Additionally, I have noticed that if you apply the protector dead center, you won't get the color halo by the edges of the visible screen. However, if you miss the center even by a little bit, you may get the halo where the light catches on the edge of the screen protector.The rounded sides of the screen protector feels quite comfortable to use compared to other protectors that don't have this feature! It's amazing how big of a difference these rounded sides made! Forced touch seem to be functioning fine, as well. Great packaging.

This screen protector lasted for an admirable 18 months. I believe I drop my phone less than the average person, and I tend to have good luck (knock on wood) with durability. After that time, the screen protector was cracked on two corners (small cracks) and was starting to separate from the screen near the top on the sides. I replaced it with another one of the same model because I was so satisfied with this one. After I got it off, I tested how the glass held up to a hammer on the corner and tested the strength of the glass to its breaking point. The hammer did crack one of the remaining intact corners when it was held on a flat surface, but it did not splinter or shatter, just a single crack. I was also very surprised with how much pressure it took before submitting. I suspended it between the jaws of a vice and pressed until it broke, which was not something that I could do with just one finger - it took both of my thumbs to press right in the middle.

I recently got a Spigen Glas.tR Slim, and even after following a meticulous method (detailed below), there's several bubbles around the edges that seem to keep getting bigger. It's been a day since I applied it, but the bubbles on the bottom edge of my screen and around my ear speaker are getting bigger, even though it states on the guide "smaller bubbles should disappear within 1-2 days".Not to mention the cut-outs for the front camera/speaker and TouchID do not line up. So if I align the top holes, the cut out for the TouchID is way off to the left (almost covering part of it). And lastly, I know it's stated on the item details that the glass is supposed to be shorter than the actual black screen to accommodate iPhone 6s rounded edges, but it's way too short. I looked the reviews and a lot of people are having issues with the width for 6s. I was willing to look past the rainbow effect on the sides, but the bubbles and ill-fitted cutouts are really bad.APPLICATION1. Let the shower run for 10 min to get rid of dust/debris floating around. Wiped the counter/everything around me, washed and let my hands air dry.2. Used the WET wipe, followed by the DRY wipe included in the package. I literally cleaned the screen for around 15 minutes, making sure that it was absolutely spotless.3. Peeled the back adhesive cover, lined it up with the top cutouts and immediately applied it to the phone. I followed the instruction of pressing in the middle. Note: I also made sure that nothing touched the adhesive side before it went on the phone. I thought I was done but I noticed bubbles around the edges of the screen and how skewed the cutout was for the TouchID.I’m not sure if this is just a dud, but this looks really bad. There’s bubbles all around the edges, a part of the TouchID is covered by the glass, I can clearly see a large part of the black screen uncovered. I’ve always been a fan of Spigen cases, but this is my first time purchasing the tempered glass—BIG mistake! My screen looks awful and I’m out $7.99!

I just received this and applied it, so I cannot attest to its longevity or how it handles drops. I'm posting an early review because this screen protector is not wide enough to cover the full front of the iPhone 6. It just barely lines up with the screen; in fact, I accidentally put it on slightly crooked, so two corners are peaking out. Even if I didn't apply it crooked, though, it still just barely covers the black portion of the screen.I've used this in conjunction with the Otterbox Defender, which was recommended by a reviewer (on the Otterbox). However, this is not wide enough to align with the Otterbox case. So, there is a gap on each side, between the Spigen glass and otterbox case, which will allow dust and debris to get trapped in the case against the phone. Ignoring those issues, it is nicer than the screen that came in the Otterbox case, especially the portion that covered the home button, which was flimsy and annoying.------------------Update, April 20, 2016: I've just removed this cover from my phone. The right and left sides were clearly lifting on their own, and I suspect that the glass cover may be causing "ghost touching" on my device. I'm removing it and waiting to see if the ghost touches disappear. I removed this using a credit card, so it did not crack, but it did leave a little bit of adhesive. As a whole, I feel that this was a waste of $8, and I would not recommend it.

The tempered glass saved my phone from being damaged. Someone hit my elbow and the phone went flying on the road, and got run over by a sedan. The display stopped working and there was a huge scratch on it. Apple care charges you for physical damage... and the screen costs a lot. To my surprise, when I removed the tempered glass, there was not a single scratch on the display. This tempered glass saved me nearly 10-15k in damages, which would be the screen replacement costs at the Apple store for an iPhone 6/6S/7. I didn't narrate what happened to the phone, just handed it over, and the screen was replaced, no questions asked.

Se trata de un vidrio grueso que no tiene nada que ver con las laminas protectoras. Una vez puesto la pantalla se ve bien y no interfiere en los gestos con los dedos. Es mas pequeño que el frontal del iPhone tanto en anchura como en altura. Para mi, rompe bastante la estética del teléfono ya que es color plata y el frontal es blanco y se nota.El gran problema y por eso le pongo una estrella, es que el ancho del vidrio es igual que la parte de pantalla que se ilumina del teléfono. Esto provoca que si el vidrio lo ajustas a la izquierda se queda muy justo en el borde derecho de la pantalla que se ilumina por lo que el canto del vidrio muestra un efecto arco iris que para mi es molesto. Muy defraudado ya que se trata de una marca reconocida a la que había comprado antes. No recomiendo su compra. Un saludo.

A prima vista la qualità del vetro utilizzato per la pellicola è molto buono, anche una volta applicato risulta essere molto bello al tatto e soprattutto facile da pulire (a differenza di alcune pellicole economiche che risultano sempre sporche anche dopo averle pulite per bene).Il motivo delle 3 stelle è dato dal fatto che su iPhone 6s (ed immagino anche sul 6 essendo praticamente uguali) la pellicola non fa perfettamente aderenza (visti gli spigoli arrotondati) e quindi rimane una sorta di contorno non molto piacevole alla vista, nonostante abbia utilizzato tutti gli accessori in dotazione.

Titolo: ERO UN FAN DI SPIGEN.A differenza di altre recensioni sottolineo che mi è arrivata la confezione originale, priva - tuttavia - del foglietto che "certifica" l'originalità di tutti i prodotti Spigen.La pellicola è troppo piccola per lo schermo, anche abbinata ad una cover Spigen lascia un margine tra la pellicola e il bordo che in un giorno si è riempito di polvere. Pellicola messa su iPhone NUOVO, appena scartato, seguendo in maniera pedissequa le istruzioni.- Viste le dimensioni calcolate al micron sullo schermo è difficile da collocare correttamente e dovendo centrare perfettamente il display un minimo errore di parallasse pregiudica il posizionamento.- Non attacca bene. C'è poco da fare. A distanza di poche ore mi si è formata una bolla vicino al pulsante home e ci si sono infilati sotto dei pelucchi di polvere. Anche sui bordi dello schermo si nota che l'adesione non è perfetta.Solita chiosa: MENO PACKAGING, PIÙ FUNZIONALITÀ. Il packaging è immondizia.PRODOTTO RESTITUITO.

I have had to replace the screen protector twice before and now the third time is needed. Very easy to install and does not affect the use of the phone. And it does protect your screen.However you have to be more careful using the phone as normal wear and tear does damage the protector. The edge wears very easily around the home button and starts to lift.The company give a lifetime warranty, but the cause of the damage has to fit their definition. However they are very fair.