DIGITENWTC100 Wireless Temperature Controller Plug in Outlet Greenhouse Heater Remote Control Reptile Thermostat Heating Cooling Mode for Homebrewing Wine Cellar

Great device, works exactly as intended. I have nothing negative to say and I would recommend.

Just bought and tested it. It worked. Turned my heater on & off automatically with desired temperatures… does exactly what it says on the package!I will keep testing it over the winter for battery life and accuracy. A great idea to save on energy bills atm 👍🏾

Excellent item. Worked really well. I used mine on a radiator in the garage and it kept it at a nice temperature.

Just what I needed to keep my homemade bottle-conditioned ale at the right temperature. My regular fridge chills the beer too much for my liking; it's also full of food most of the time. So I bought a special drinks chiller. Even that has a maximum temperature of 10°C, which is still too low for my liking. I prefer it to be in the range 12°C to 15°C. I needed this thermostat to set the correct temperature range. The remote temperature sensor sits inside the chiller and communicates with a thermostat on the mains socket, into which the chiller is plugged. So as soon as 12°C is reached the fridge goes off. When the temperature has climbed to 15°C it starts chilling again. It works perfectly and I can change the temperature range to whatever I like. For instance, I could set it a lot colder for Champagne if I needed it for a party. I recommend this device.

I purchased this item to measure the temperature in my attic where solar equipment is operating. I wanted to know in the peak summer months what the temperature was and to have this info remotelyIt never worked properly and looking at returning it (if poss) or binning it

Was easy to set up great for keeping caravan warm at night but if you want hot water during the day you have to unplug it mind you it stores the instructions so it's a mater of unplugging it use your hot water then put it back in it's fine

I have a log burner and have fitted a 100mm ducting with an inline fan through the ceiling joists to the landing upstairs to move the hot air around to heat the whole house. I have set this to turn on the fan when the temperature by the fire gets above 24*c and then when the temperature drops down below 22*c it will turn off again. I never have to worry about it, it does everything I need it to do.Definitely recommend.

I bought this in October 23. I had issues setting this thermostat up as the first remote thermostat control didn’t work but I had bought two plugs and eventually managed to set the second one up to control two sockets supplying my conservatory heaters. The thermostat is unnecessarily complex setting an upper and lower level and if you don’t use the wired probe socket then instead of the ambient temperature display you get code Err. Crazy. However the worst is the alarm function. It is factory set to disable ie default. After changing batteries, the control unit went into alarm mode. The instructions tell you to get to the High /low page ie press Set, the hold Set. 3sec…then keep pressing the up/down button until OF displayed. What it should tell you is on high setting press the UP button until OF displayed , and THEN go to Low and press the down button until OF displayed. I contacted on line Digiten and they responded immediately and indicated a helpful you tube video .