KneeRover Premium Knee Walker Ergonomic Hand Grips - Universal Upgrade Knee Rover Replacement Part Fits Most Knee Scooters - Includes 2 Comfortable Hand Grips

These handles are a great replacement part for my Knee Rover Pro. They fit snugly and seem stable when installed. They are about an inch or so shorter than the original grips but seem OK so far.

Great product

I like the fact that these grips are bigger around than the original grips that were installed from the manufacturer and they include end caps to finish the look. also these grips are textured to allow for a positive grip even with wet hands.

workek well

The right handle would not slide on all the way until we used some baby powder. Now it slides too easily. Grip is comfortable.

You will experience a degree of difficulty installing these grips for two reasons: 1 the diameter on the grip runs small, 2. they don't soften up easily for installation.I managed to ruin the distal end of one grip due to the small diameter and add to this is the difficulty warming up the grip so it could be installed. I used hot water to soften the grip along with hair spray to ease the installation and to lock the grip in place when installed.A third issue is they are not very long and are smaller than the width of my hand. All said, they are still better than the OEM grips and a lot less costly.

I have worked on knee scooters for several years but recently came in need of one myself. I now live where they are hard to come by but got a used one that only had duct tape for grips. I ordered these and love them. I had one installed by the wiggle and twist method (patience) but with the second one the cap was crooked. I removed the cap from the grip and put it in first. If the cap fits, the grip will. More wiggle and twist or a push against a sturdy solid surface will get it on. PLEASE do not lubricate. Safety first is foremost with any medical equipment.

Way better than the original grips. Looks good and greatly reduces hand fatigue. Hardest part is getting old ones off. I used a long skinny flat head screwdriver to slide under old grip as far as pissible and squirt in isopropyl alcohol, wiggle them back and forth and they slid right off. (The alcohol works so much better/faster than wd40 method) clean off the handles and spritz a little hairspray inside the grip and slide on into desired position.