[ Round ] Star-Lord decorations batman led light flexible helmet lights cosplay diy kit rgb superhero for men gifts

2 simple LEDs that can be placed wherever. Be careful removing the covers since it's part of eye covers. They are see-through once removed. I cut the white covers to protect the LEDs but removed most of it so I could see while wearing them. You may need to mod them if you want to put the batteries on your body instead of inside the mask or helmet. The on Switch is small and on the batteries. So it can't be accessed without removing the wear if it's a full mask or hard to reach outfit.

These work Awesome and for the price, you can't go wrong!

These are cool and my son used them for a Halloween costume.

They bend just enough to fit perfectly. They're bright enough to show off in a room. I've used these for a few helmets and by far my favorite. They're durable enough to take a ton of hot glue and still work lol. They're brighter than the v1 version and battery pack is better.

Absolutely perfect met my expectations in every way.

My second pair and the glue melted away causing the LED wire to disconnect.The white dot print needs to be done in two steps. First a black and then a white. The bright white dot washes out your vision. Otherwise you must painstakingly dot each white spot with a fine tip marker so you can see partially should you want to see at all.Flexible clear rubber makes it easy to bend into the eye sockets of your helmet or prop where you wish some general color hue. It also can be cut with heavy scissors or blade. If you’re using a blade be careful because the lenses are small and smooth. Recommend a chopping method.

Yes, these are easy to bend. Beware of several other brands out there that claim to be bendable - but you will just end up breaking them.

I ordered 2 sets of the LED eye covers, by accident, I plan to use both but have only used 1 so far. I found that the first set had a protective covering over both sides of the lenses. While removing the protective cover I found that the temporary adhesive holding the covering on was very messy. The adhesive smeared on the lens a bit, causing a blurry area on one end. It was about the same time that the LED for one lens came out completely. The other lens' LED came out soon after the first. They weren't held in by much at all, if anything. I ended up using a hot glue gun to secure the leds back in the correct location. There's also a reflective metallic strip around the outside edge of the lenses, that's not adhered very well, also. I was able to get these to work with a little extra effort, but it was extra work that the buyer shouldn't have to do.

The media could not be loaded.  This light kit is actually pretty good and I’m glad for the price. Honesty think it is a bit expensive for what it is but other than that I would say it’s definitely worth it

The media could not be loaded.  I like that it’s small and compact. I don’t need to use the adhesive so I’m not sure how well that works, but you can’t select between colours or strobe timing, it’s on or off. Cycling through every colour and every flash type. Which I guess would be ok if THEY MATCHED. They don’t. One is welllll behind the other. Not just like a little. Inconvenient and annoying. Kinda my only option is to remove one and close off that wire. Too much money for a bummer of a product

Very flexible and had no trouble

Según el paquete venían dos y solo llego uno ...