Safego 50W 6ohm LED Load Resistor - Fix Hyper Flash Turn Signal Blink Error Code for Turn Signal Light, License Plate Lights, DRL

bought the 50w 6 ohm load resistors due to fitting LED units and having "hyper flash" when indicating. Fitted this kit in around 15 minutes. very easy to fit and works perfect. does get slightly hot when the indicators are on for a prolonged period of time so something to bear in mind when sticking the resistor down (i.e. not near to plastic or fabric). A little bit of double sided tape on the bottom would be a good addition. However I had some lying about just to stop it moving. Quick splice connectors are included. A set of pliers or pump pliers are needed to fully close the metal blade.

I tried 2 different makes of Canbus error free T15 (921) LED bulbs, both of which give an error lights out message on the dash in my standard 2012 Audi TT 1.8 TFSi coupe. Its only the reverse lights i want to be brighter. After fitting these resistors the error messages have finally stopped. I have left the car in reverse for 2 mins to test the heat of the resistors, they only got slightly warm, so absolutely fine for reversing light application.

A1

Perfect item

Work as expected but do get very hot, however for about 6 month I wired them in wrong, you have to remember to wire them across the positive and negitive connecting the two, seemed counter intuitive to me but now they work great. I used them on a John Deere 6170R to allow LED flashing beacons, without a canbus fault showing.

one keeps flickering its ok for about 30 mins and then goes off comes on then off

Worked in my Audi a3 I had LED lights but the car thought the bulbs was blown. Wired these up nice and easy about 20 mins now car no longer has error and has no affect on the way the lights work. Will be ordering more for my full beams now

Fitted to a 2015 seat Leon with LED headlights to replace the horrible yellow fog lights, they match the colour of the headlights (cool white) perfectly and using the carista device I have also activated cornering fog lights. Great product.

These are great resistors but the included wire taps are junk.You should do a proper job and make the wire connection in a better way.

No he tenido ningun problema despues de instalarlas en un Volkswagen, el sistema Canbus lo detecta bien y si quito el LED lo detecta como fundido.Solo no lo instalen cerca de algo que se pueda derretir o quemar por que si se calientan al estar en uso

Easy to install

The resistors did what I expected, no more flickering in my back up led bulbs. Best to solder the connections, use heat shrink tubes and electrical tape. Spliced into the b/u bulb wiring inside the tail lights to keep out of the weather elements. Works great as long as it's done properly the first time.

Direi che si presentano molto ben rifinite e svolgono il suo lavoro in maniera impeccabile.La confezione sarebbe da rivedere ma per il resto anche la fornitura di serie le rendo semplici per l'installazione.