Rubber Feet Strips Replacement HP Envy X360 Convertible 15.6 Laptop with Stainless Steel Lever and Tweezers (Black)

Got these to replace the rubber strips that I had to remove to upgrade my HP Envy x360 when one of them tore apart when I was removing it. These strips fit well enough (they are a tad bit wider than the one's that were originally on the system -- and just few millimeters longer than the channels for them on the laptop, but a quick trim took care of that.) So far, the adhesive on them seems to be holding well enough. No issues so far.My only complaint is the cost.... these things should run between $3-$5, rather than $11, but then, they are much less costly than what HP originally sold replacements for, so there's that. I suppose I could have gotten along with out these, but I do appreciate my laptop to be no-sliding on a smooth desktop.

I repaired a cheap HP laptop for a friend. And to get at the screws, you have to remove the rubber strips on the bottom of the laptop. Doing this is likely going to destroy the strips and this is about the only option to make the laptop sit still after repair. Plus you get a couple decent tools that you might not already have. These tools are often similar to Fix-it tool kits you see for less than $20 here on Amazon.This hiding screws under flimsy rubber is a horrible thing I have only seen on budget HP laptops so far. Guess they rather you just buy another computer than move the screws over a 1/4 inch. Glad I buy Dell and Asus for my own kit.Also, might have been my mistake, but I was pretty certain I ordered silver/gray. I received black. Anyhow, might be better looking with a silver PC having black feet.

I like that these are slightly thicker than the factory feet so it feels a little sturdier. Very grippy, so it doesn't slide easily.I thought that since I was ordering for a specific laptop, that they would just fit, but they were too long and I had to cut them down more than two inches each. But they still look good and function perfectly. Would buy again if I needed them, but I think these will last the rest of the laptop's life.

I properly cleaned the area and installed as instructed. They did not last 2 months; they peeled off and no longer stick. Waste....I wish I could get a refund.

This product is a little wide for the HP Spectre X360. It doesn't fit into the plastic groves and hangs a little over on each side. Many reviewers already mentioned this. It does stick down when installed, but it really isn't a perfect fit. These were probably made for a different computer but being sold to match the 15 inch X360 also. They are also a hair short, but this is not really an issue for installation. Reasonable value, just wished they fit better.

Perfect size and have been holding on GREAT for over a year!

It was too wide and too long so I had to get out my exacto knife, which was kind of annoying but fine whatever, but then the sticky backing didn’t even stay stuck to the computer and it started falling off only a couple of days after I got it on! And I even used rubbing alcohol on the laptop before hand to really prep the surface for sticking, and it still didn’t make any difference :/

I purchased these when the front strip on my laptop started falling off and HP didn't offer a replacement. I applied the strip yesterday, and the hardest part was getting the adhesive's paper off. By the time I was able to remove the paper some of the adhesive had lifted off some of the rubber foot.Initially the foot did look too short; however, I discovered that the feet do stretch some, resulting in a perfect fit.I still like the design and fit of the original better and can see based on how it fits in the groove that it is likely going to lift after a few months; however, this is better than nothing.