dynofit 1.25" 6x5.5 Wheel Spacers for Toyoya Tacoma, 4Runner, Tundra, FJ Cruiser, 6x139.7 Forged Spacers M12x1.5 Studs 106mm Hub Centric 1.25" Thick with Extended Lug Nuts for Lexus GX Series, 4Pcs

Product is good, but the manufacturer have to include the problems caused when you install this on low profile trucks or autos. I installed on tacoma 2018 and have some troubles. The tires touch the edge of platics arround the tire. I have to lift the truck 3” after that to prevent that issue

Good fit

Giving 4 stars because easy install looks dope but, it wobbles and vibrates real bad and rubs when doing sharp turns and backing into a parking spot installing 2inch leveling kit so well shall see if this fixes the problem

Muy buenos queda bien

Buwno

Pros:Fit nicely on the truck.Come with red lock tide.The stud itself is long enough to hold the wheelCons:The nuts it came with are way too short, only able to hold half of the stud from the truck.I have to get the open end lug extension for it to work. Otherwise it would be dangerous to run with the lugs but that it came with.

Before and after pics. 265 wide tire. I've used spacers before. These spacers are quality and are safety standard. There's a post below saying the stud broke off......look, the only way that stud is breaking off is by someone at the tire shop putting a nut on the end and tightening it until it snaps. It could happen to the primary wheel stud at the hub as well. Use the right torque specifications for wheel studs from the manufacturer. It can be hard when you have a so called professional install them. Most of the time it's some huligan out of high school experimenting on you car.

Mounted these on an FJ 80 series to get proper offset and they were built well and worked perfect. Fit and finish was great on these!

WHEEL centered! My hub does have 106.3mm diameter, so these spacers are definitely wheel centered! The review before didn't not a good job or the spacers were not deep enough and they looked for an excuse to return them.They do fit excellent on my Toyota Land Cruiser ! No wobble, runs like a dream and give my ride the final stability because I've got a high roof on it... 278cm height in total. Make sure to remove all the rust on your hub to have a really flat area. I also used Loctite for the inner nuts, torque them by specs (156Nm) on my Cruiser.I had to do the alignment anyways so it was a proof at the same time they are good!By the way, excellent customer service!Thank you guys.