Zoomtools12Pcs Valve Spring Compressor tools Kit, Auto Compression C-Clamp Tool Service Set with Valve Lapping Grinding Stick Tool, for Motorcycle, Car, ATVs, Trucks

Excellent piece of kit, bit fiddley to get set up right to start with on a motorcycle head but once you get it set very easy to use. Feels solidly built even the grinding suckers work great. For £21 what's not to like!

Good value for money, more than capable of doing the job

This tool does not reach all the valves on a ford transit 2014 van cylinder head. if your mechanically minded you can get around it but only just with some extra bits of metal.

👍🏼👌🏼

should work for most cylinder heads, better than some I have used.

Very good

Easily helped me remove the valves from my 1977 Yamaha xs750 project

The box comes in with the following items:1) 5 different sizes for different springs/fittings.2) U-Bar holder to connect:3) 2 x 15cm screws4) The red carry bag5) 2 x suction cupsThe parts (apart from suction cups) are cast-iron and the product was priced at £29 which is not too bad.The downside:A) The suction cups were too fragile, did not hold at all and could hardly be used, they looked very cheap.B) Fitting the spring holder onto the side screw was a little challenge, mainly because the product was cast-iron (not stainless steel) the rounded part where the barrel fits onto the screw was not machined with a 90-degree level, this resulted in an un-even rotation, fitting anything else other than a spring did not work well.C) The product was covered in grease, not just the screws but all parts.D) Due to having 2 x screws on each side; sometimes one of the screws would move upon tightening the other side.The tool was not bad to use, just inaccurate, greasy, with few cheap parts.